To Next PageTo Next Page
Need help?Do you have a question about the Dennerle CO2 Flipper and is the answer not in the manual?
General| Brand | Dennerle |
|---|---|
| Model | CO2 Flipper |
| Category | Pet Care Product |
| Language | English |
Rinse the CO2 Flipper with warm water and attach the CO2 supply hose to the connector.
Select a spot with good water circulation, not too bright, and attach vertically.
Set the required CO2 amount on the needle valve of the pressure reducer.
Use special check valves designed for CO2 to prevent corrosion from water intake.
Use the DENNERLE CO2 Long-term test Correct for easy and permanent CO2 measurement.
Ensure vertical mounting and allow running-in time; adjust water circulation if needed.
Check vertical mounting and ensure the collector is attached straight and not clogged.
Clean the CO2 Flipper to remove algae growth or deposits obstructing the flow.
