1. Charging
Charge the earphones using the included charging case and
USB cable before use.
1. Put the earphones in the charging case (included) and
close the lid.
Remove the power supply prevention film from the
earphones in advance.
2. Connect the charging case to the AC adapter
(commercially available) with the USB cable (included).
The LED on the charging case will light up according to the
remaining charge of the earphones.
•More than 20 %: Blinking green
•Less than 20 %:Blinking red
•Fully charged:Solid green
It will take approx. 2 hours from empty to full charge. The
earphones can be used for approximately 5 hours (with
noise cancel on) when the battery is fully charged. When the
rechargeable battery is low, a notification sounds.
2. Pairing with Bluetooth device
Pair the earphones with the Bluetooth device you want to
connect.
1. Open the lid of the charging case.
The earphones will automatically turn on, and the pairing
mode will be activated with a notification sound from the
earphones.
2. Activate Bluetooth function of the Bluetooth device to
be connected.
3. Select the “DENON AH-C630W” appears on the
Bluetooth device to be connected.
A notification sound will be heard from the earphones when
it is connected.
•If you are requested to enter a PIN code (pass key), enter “0000” (four
zeros).
AHC-630W EM_Dummy for DPP_210525.indd 1 2021/05/25 17:32:25
© 2021 Sound United. All Rights Reserved.
To Next Page
Need help?
General
Weight and Dimensions
