Denon AVC-A11SR - Page 16

16
ENGLISH
NOTES:
• The OPTICAL 4 and 5 jacks on the AVC-A11SR’s rear panel are equipped with an optical digital output jack
for recording digital signals on a DAT deck, MD recorder or other digital recorder. Use this for digital
recording between a digital audio source (stereo - 2 channel) and a digital audio recorder.
• Do not connect the output of the component connected to the OPTICAL 4 OUT jack on the AVC-A11SR’s
rear panel to any jack other than the OPTICAL 4 IN jack.
• Do not connect the output of the component connected to the OPTICAL 5 OUT jack on the AVC-A11SR’s
rear panel to any jack other than the OPTICAL 5 IN jack.
•“PHONO” cannot be selected on the Digital In Assignment screen.
• Use this to turn the on-screen display (messages other than the menu screens) on or off.
Setting the on-screen display (OSD)
1
At the System Setup Menu select “On Screen Display”.
BAND MODE
TUNING
TUNING
2
Switch to the On Screen Display screen.
ENTER / SHIFT
SELECT
3
Select “ON” or “OFF”.
BAND MODE
TUNING
TUNING
4
Enter the setting.
The System Setup Menu reappears.
ENTER / SHIFT
SELECT
• On-screen display signals
1
2
3
4
Signals input to the AVC-A11SR On-screen display signal output
VIDEO signal input
jack (yellow)
S-video signal
input jack
VIDEO MONITOR OUT-1 video
signal output jack (yellow)
S-video MONITOR OUT-1 video
signal output jack
E
C
C
E
E
E
C
C
C
C
E
E
C
E
C
C
(
C
: Signal
E
:
No signal)
NOTES:
• The on-screen display signals are not output from the video signal MONITOR OUT-2 (yellow) or S-Video
signal MONITOR OUT-2 jacks.
• The on-screen display signals are not output from the color difference (component) video signal MONITOR
OUT jacks.
• For 4 above, the on-screen display signals are output to the VIDEO MONITOR OUT-1 video signal output
jack (yellow) if the monitor TV is not connected to the S-video MONITOR OUT-1 video signal output jack.
This button can be pressed at any time during the system setup process to complete the process.
After completing system setup
1
At the System Setup Menu, press the SYSTEM SETUP button.
The changed settings are entered and the on-screen display turns off.
This completes system setup. Once these settings are made, there is no need to change them unless
different AV components are connected or the speakers are repositioned.
(
C
: On-screen signals output
E
:
On-screen signals not output)