•To connect the video output from the DVD player to the AVC-A11XV, you only need to choose one connection
type. Component video connection offers the best quality (and is required for progressive DVD playback),
followed by S-Video, while composite video offers the lowest picture quality of the three connection types. For
more information about the video up conversion function ( page 12).
• The AVC-A11XV is equipped with HDMI connectors, so it can be connected to a DVD player or monitor TV using
an HDMI cable. To connect it to a DVD player using a DVI-D cable ( page 17).
•To connect the digital audio output from the DVD player, you can choose from either the coaxial or optical
connections. If you choose to use the optical connection, it needs to be assigned. For more information about
Digital Input Assignment ( page 42).
• The AVC-A11XV is equipped with another set of input terminals for a non-DVD Video Disc Player (such as laser
disc, VCD/SVCD, or future high definition disc player). The above connection guidelines for DVD also apply to
the VDP input.
• For best picture quality (especially with progressive DVD and other high definition sources) choose the
component video connection to your monitor TV. S-Video and composite video outputs are also provided if your
TV does not have component video inputs.
Audio signal flow is shown with white arrows, white video signal flow is shown with gray arrows.
NOTE:
• The component video input and/or output jacks may be labeled differently on some TVs, monitors or video
components (Y, P
B, PR; Y, CB, CR; Y, B-Y, R-Y). Check the owner’s manuals for other components for further
information.
• The COMPONENT MONITOR OUT-1 and the COMPONENT MONITOR OUT-2 can be used simultaneously.
• Audio signals are only output from the HDMI monitor out terminal when audio signals are input to the HDMI
input terminal.
• When connecting the AVC-A11XV and DVD player using an HDMI cable, also connect the AVC-A11XV and
monitor TV using an HDMI cable ( page 16).
To Next Page
Loading...
