Denon AVC-A11XV - LEVEL DIAGRAM; ZONE 2 L;R ch

14
ENGLISH
Connecting Other Sources Connecting Other Sources
ENGLISH
Connecting the external inputs (EXT. IN) terminals
DVD Audio-Video /
Super Audio CD Player /
External decoder
R
SURROUND
BACK
L
R
SURROUND
L
R
FRONT
L
7.1ch AUDIO OUT
CENTER
SUB-
WOOFER
R
L
R
L
R
L
R
L
B
A
B
A
R
L
R
L
A
• These terminals are for inputting multi-channel audio signals from an outboard decoder, or a component with
a different type of multi-channel decoder, such as a DVD Audio player, or a multi-channel Super Audio CD player,
or other future multi-channel sound format decoder.
• The method of video signal connection is the same as that for DVD player ( page 7).
• For instructions on playback using the external input (EXT. IN) terminals ( page 21).
• Playback using the DENON LINK connector Digital transfer and multi-channel playback of DVD audio discs and
other multi-channel sources is possible by connecting the AVC-A11XV to a DENON DVD player equipped with
a DENON LINK connector using the connection cable included with the DVD player.
•With discs on which special copyright protection measures have been taken, however, the digital signals may
not be output from the DVD player. In this case, connect the DVD player’s analog multi-channel output to the
AVC-A11XV’s EXT. IN terminals for playback. Also refer to your DVD player’s operating instructions.
Connecting a video camera component or video game component
Video camera /
Video game
S VIDEO
OUT
R
L
AUDIO OUT
VIDEO
OUT
OPTICAL
OUT
R
L
R
L
H
I
A
D
Connecting a DVD recorder
DVD recorder
S VIDEO
OUT
S VIDEO
IN
R
L
AUDIO IN
R
L
AUDIO OUT
VIDEO
OUT
VIDEO
IN
OPTICAL
IN
OPTICAL
OUT
R
L
R
L
H
H
I
I
A
R
L
R
L
A
D
D
COMPONENT VIDEO OUT
Y
P
B
PR
J
• For best picture quality choose the component video connection to your DVD recorder. S-video and composite
video outputs are also provided. If you choose to use the component video connection, it needs to be assign.
For more information about Component Input Assignment ( page 45).
• If you wish to perform analog dubbing from a digital sources, such as a DVD recorder to an analog recorder
such as a cassette deck, you will needs connect analog inputs and outputs as shown below, in addition to the
digital audio connections.
NOTE:
• When recording to DVD recorder, it is necessary that the type of cable used with the playback source
equipment be the same type that is connected to the AVC-A11XV VCR-1 (to 3) OUTPUT terminal.
(Example) VCR-1 IN
→ S-video cable : VCR-1 OUT → S-video cable
VCR-1 IN → video cable : VCR-1 OUT → video cable
• Do not connect the output of the component connected to the OPTICAL 2 OUT terminal on the AVC-
A11XV’s rear panel to any terminal other than the OPTICAL 2 IN terminal.