Denon AVC-A11XV - ZONE3 L;R ch

ENGLISH
15
ENGLISH
Connecting Other Sources Connecting Other Sources
Connecting a VCR
Video deck
S VIDEO
IN
R
L
AUDIO IN
R
L
AUDIO OUT
VIDEO
IN
S VIDEO
OUT
VIDEO
OUT
R
L
R
L
H
I
H
I
A
R
L
R
L
A
• There are three sets of video deck (VCR) terminals, so three video decks can be connected for simultaneous
recording or video copying.
NOTE:
• When recording to VCR, it is necessary that the type of cable used with the playback source equipment be
the same type that is connected to the AVC-A11XV VCR-1 (to 3) OUTPUT terminal.
(Example) VCR-2 IN → S-video cable : VCR-2 OUT → S-video cable
VCR-2 IN → video cable : VCR-2 OUT → video cable
• Do not connect the output of the component connected to the OPTICAL 3 OUT terminal on the AVC-
A11XV’s rear panel to any terminal other than the OPTICAL 3 IN terminal.
Connecting a CD player
R
L
AUDIO OUT
CD player
COAXIAL
OUT
OPTICAL
OUT
R
L
R
L
A
C
D
•To connect the digital audio output from the CD player, you can choose from either the coaxial or optical
connections. If you choose to use the optical connection, it needs to be assigned. For more information about
Digital Input Assignment ( page 42).
Connecting a turntable
AUDIO OUT
GND
Turntable
R
L
A
•You can connect the turntable (MM cartridge) to the PHONO terminals.
NOTE:
• The phono input can accept signals from moving magnet (MM) and high output moving coil (MC) phono
cartridges. If your turntable is equipped with a low output MC cartridge, you will need to use a separate MC
head amplifier or step-up MC transformer.
• If humming or other noise is generated when the ground wire is connected, disconnect the ground wire.
Connecting a CD recorder or MD recorder
R
L
AUDIO IN
R
L
AUDIO OUT
CD recorder /
MD recorder
OPTICAL
OUT
OPTICAL
IN
R
L
R
L
A
R
L
R
L
A
D
D
• If you wish to perform analog dubbing from a digital source, such as a CD or MD recorder to an analog recorder
such as a cassette deck, you will need to connect analog inputs and outputs as shown below, in addition to the
digital audio connections.
NOTE:
• Do not connect the output of the component connected to the OPTICAL 4 OUT terminal on the AVC-
A11XV’s rear panel to any terminal other than the OPTICAL 4 IN terminal.
Turntable
(MM cartridge)