ENGLISH
17
ENGLISH
Connecting Other Sources Connecting Other Sources
Connecting equipment with DVI (Digital Visual Interface) terminals
DVD player
Monitor TV
HDMI
IN
DVI-D
OUT
COAXIAL
OUT
OPTICAL
OUT
K
L
D
C
R
L
AUDIO OUT
R
L
R
L
A
• Connection with equipment that has a DVI (Digital Visual Interface)-D connector permits the transfer of digital
images. Make an analog or digital audio connection also.
NOTE:
• Commercially-available DVI cables are available in 24-pin and 29-pin types. The AVC-A11XV supports the
24-pin DVI-D cable.
• The AVC-A11XV supports HDCP. Use an HDCP-compatible HDMI monitor.
• When connecting via a DVI-D cable, no digital audio will be output from the HDMI Monitor Out connector.
• If your digital TV monitor only supports DVI-D, please obtain and use an HDMI-DVI conversion cable or adaptor,
available from your dealer.
2 Connections with an HDMI/DVI-D conversion cable (adapter)
•The HDMI video stream signals (video signals) are theoretically compatible with DVI-D. When connecting to a
monitor, etc., equipped with DVI-D terminals, it is possible to connect using an HDMI/DVI-D conversion cable,
but depending on the combination of devices used the image might not be output.
• When using an HDMI/DVI-D conversion adapter, the image may not be output properly due to poor contact with
the connected cable, etc..
• For stable signal transfer, we recommend using cables that are a maximum of 5 meters in length.
Connecting IEEE1394 devices
• For the digital transfer of signals from Super Audio CDs and DVD-Audio discs, connect using an IEEE1394
cable. For instructions on playing Super Audio CDs ( page 39).
• Assign the IEEE1394 input the input source. For details, see “Setting the IEEE1394 Assign” ( page 43, 44).
• IEEE1394 network
q Up to 17 devices can be connected using daisy chain type connections.
w Up to 63 devices can be connected using tree type connections.
Do not loop the connections.
e “LINK CHECK” is displayed when an input source to which an IEEE1394 is assigned is selected and
connection to the IEEE1394 device is being checked.
r If the connection is looped, “LOOP CONNECT” is displayed. Check the connections and undo the loop.
NOTE:
• The AVC-A11XV will not operate when connected to equipment other than that conforming to “IEEE1394
AUDIO (A&M protocol)” standards or when connected to computer peripherals.
Also please note that operation is not guaranteed even when connected to IEEE1394-compatible
equipment. Whether or not data and control signals can be sent and received between interconnected
IEEE1394-compatible equipment depends on the functions of the different equipment. Please read the
operating instructions of the equipment to be connected.
• Use an S400-compatible 4-pin IEEE1394 cable to connect.
•Video signals are not transferred with the AVC-A11XV’s IEEE1394 interface, so when connecting a video
device connect the video signals as well.
To Next Page
Loading...
