Denon AVC-A11XV - ADJUSTMENT; AUDIO Section; IDLING CURRENT (1 U-3356-1,2)

ENGLISH
18
ENGLISH
Connecting Other Sources Connecting Other Sources
Connecting the MULTI ZONE terminals
Power amplifier
(ZONE2 or ZONE3)
R
L
IN
Monitor TV
(ZONE2 or ZONE3)
S VIDEO
IN
VIDEO
IN
++
AUX OUT
R
L
R
L
H
I
A
For instructions on operations using the MULTI ZONE functions ( page 37 ~ 39).
ZONE2 (or ZONE3) pre-out connections
•If another power amplifier or pre-main (integrated) amplifier is connected, the ZONE2 (or ZONE3) pre-out
(variable/fixed level) terminals can be used to play a different program source in ZONE2 (or ZONE3) the same
time ( page 38).
• The ZONE2 (or ZONE3) video out is only for the ZONE2 (or ZONE3).
Connecting the CONTROL terminals
These terminals are used for an external
controller.
Perform the following operation before
using an external controller connected to
the RS-232C terminal:
1. Press the ON/STANDBY button on the
main unit and set the unit to the
operating mode.
2. Perform the operation to turn off the
power from the external control.
3. Check that the product has been set
to the standby mode.
After checking the above, check the
connections of the external controller.
Operation is possible.
Connecting the TRIGGER OUT terminals
Turn the DC 12V voltage on and off for the
individual functions and surround modes.
For details, see “Setting the Trigger Out”
( page 51).
INFRARED RETRANSMITTER
INPUT
Extension terminal for
future use.
INFRARED SENSOR
OUTPUT
NOTE:
• For the AUDIO output, use high quality pin-plug cables and wire in such a way that there is no humming
or noise.
• For instructions on installation and operation of separately sold devices, refer to the devices’ operating
instructions.