Denon AVC-A11XV - Procedure

20
ENGLISH
ENGLISH
Operating the remote control unit
The RC-995 remote control has a backlit LCD screen
whose contents change according to the mode or
function selected, with the appropriate remote
commands for that mode or function.
2 SURROUND MENU
To select specific surround modes.
Press the NUMBER / SYSTEM
CALL
button to display the
screen below.
• This function provides the ability to program a series
of individual remote control codes into a macro
stored under one of the number pad’s numeric
choices ( page 32 ~ 35).
SOURCE HOME THX
CINEMA
ROOM EQ
FUNCTION VOLUME
FUNCTION
SOURCE
ROOM EQ
VOLUME
HOME THX
CINEMA
SURROUND
Playing the input source
1
Select the input source to be played.
(Main unit) (Remote control unit)
To select the input source when ZONE2 SELECT
or ZONE3/REC SELECT is selected, press the
SOURCE button on the main unit then operate the
input function selector.
2
Start playback on the selected
component.
3
Adjust the volume.
The volume can be adjusted within the range of
–80 to +18 dB, in steps of 0.5 dB. However,
when the channel level is set ( page 31 or
54, 55), if the volume for any channel is set at
+0.5 dB or greater, the volume cannot be
adjusted up to 18 dB. (In this case the maximum
volume adjustment range is “18 dB —
(Maximum value of channel level)”.)
(Main unit) (Remote control unit)
M.VOL. -80.0dB
The volume level is displayed on the master
volume level display.
2 To choose the surround sound mode
Example: THX Surround EX
Press the SURROUND button, then press the
HOME THX CINEMA button.
For more information about the surround modes
( page 24, 25).
2 To select the Room EQ function
Press the ROOM EQ button.
For more information about the Room EQ
function ( page 22).
For operating instructions, refer to the
component’s manual.
Example: CD
2 Operate the this unit
Press the SOURCE button to
display the screen shown below,
to that you can select an input
source.
The
AMP button is the main mode for
controlling the AVC-A11XV in the main
room (MAIN ZONE).
2 SOURCE MENU
To operate the system’s source components.
Press the SURROUND button
to display the screen below to
choose a specific surround
mode.
2 NUMBER / SYSTEM CALL MENU
Operate the “Number / System call” menu function.
Basic Operation
The function switches as shown below each time
one of the MODE SELECTOR buttons is pressed.
AMP/Z2 : AMP, ZONE2
Z3/Z4 : ZONE3, ZONE4*
(* : This mode can not be used with the AVC-
A11XV.)
Playback
Basic Operation