ENGLISH
25
ENGLISH
Basic Operation Basic Operation
• In addition, screen information is displayed in the
following order when the ON SCREEN button is
pressed repeatedly:
OSD-1 Audio input signal
OSD-2 Monitor information
OSD-3 Input/output
OSD-4 Auto surround mode
OSD-5 USER MODE 1
OSD-6 USER MODE 2
OSD-7 USER MODE 3
NOTE:
• OSD-2:
The monitor’s resolution is displayed when an
HDMI monitor is connected to the AVC-A11XV.
OSD-4:
This is displayed when the auto surround mode
is set to “ON” ( page 47) and the input
mode is set to “AUTO”.
It is not displayed when the input mode is set to
“ANALOG” or “EXT. IN”.
Press the HOME THX CINEMA button
to select the “Home THX Cinema”
mode.
Play a program source
with the , mark.
• The Dolby Digital indicator lights when
playing Dolby Digital sources.
light
light
2 To play in the THX surround EX /
Home THX Cinema surround mode
for sources recorded in Dolby Digital
or DTS
2 Surround parameters w
MODE/SB CH OUT:
Select the surround back channel playback method or
mode.
(1) Multi channel source
• THX Surround EX:
Dolby Digital signals are played in the THX
Surround EX mode.
• Ultra2 Cinema:
The signals are played in the THX Ultra2 Cinema
mode.
• Music Mode:
The signals are played in the THX Music mode.
• Games Mode:
The signals are played in the THX Games mode.
• NON MTRX:
The same signals as those of the surround
channels are output from the surround back
channels.
• MTRX ON:
The surround channel signals undergo digital
matrix processing and are output from the
surround back channels.
• SB OFF (OFF):
No signal is played from the surround back
channels.
• ES MTRX:
When playing DTS signals, the surround back
signals undergo digital matrix processing for
playback.
• ES DSCRT:
When a signal identifying the source as a discrete
6.1-channel source is included in the DTS signals,
the surround back signals included in the source
are played.
• PL
IIx Cinema:
Processing is performed with the Cinema mode of
the PL
IIx decoder and the Surround Back channel
is reproduced.
• PL
IIx Music:
Processing is performed with the Music mode of
the PL
IIx decoder and the Surround Back channel
is reproduced.
1
2
For operating instructions, refer to the manuals
of the respective components.
The channel status information during playback
of Dolby Digital and DTS sources can be checked
pressing the STATUS button on the main unit.
Press the SURROUND BACK
button.
Lights when the Surround
Back CH is on.
2 Checking the input signal
The input signal can be checked by pressing the
remote control unit’s ON SCREEN button ( page
21).
SIGNAL:
Displays the type of signal (DTS, DOLBY DIGITAL,
PCM, etc.).
fs:
Displays the input signal’s sampling frequency.
FORMAT:
Displays the input signal’s number of channels.
“Number of front channels / Number of surround
channels / LFE on/off”
“SURROUND” is displayed for 2-channel signal
sources recorded in Dolby Surround.
OFFSET:
Displays the dialog normalization offset value (
page 26).
FLAG:
Displays the special identification signal recorded in
the input signal ( page 26).
“MATRIX” is displayed when matrix processing is
conducted on the surround back channel,
“DISCRETE” is displayed when discrete processing
is conducted.
Not displayed when no identification signal is
recorded.
• The DTS indicator lights when playing DTS
sources.
To Next Page
Loading...
