Denon AVC-A11XV - DSP Surround Simulation

DISPLAY
SURROUND
BACK SPEAKER
30
ENGLISH
Basic Operation Basic Operation
ENGLISH
SURROUND
PARAMETER
7CH STEREO
CURSOR
DSP SIMULATION
ENTER
DSP SIMULATION
SURROUND
9CH (7CH STEREO)
SURROUND
PARAMETER
ENTER
CURSOR
DSP surround simulation
1
Select the surround mode for each input
channel.
The surround mode switches in the following
order each time the DSP SIMULATION button is
pressed:
(Remote control unit) (Remote control unit)
(Remote control unit) (Remote control unit)
WIDE SCREEN
JAZZ CLUB
SUPER STADIUM
ROCK ARENA
MATRIX
VIDEO GAME
CLASSIC CONCERT
MONO MOVIE
2
Press the SURROUND PARAMETER
button.
•Display the surround parameter menu.
3
Press the CURSOR
DD
or
HH
button to
select the various surround parameters.
5
Press the ENTER or SURROUND
PARAMETER
button to complete the
setting.
4
Press the CURSOR
FF
or
GG
button to
adjust the parameters setting.
ON
OFF
7CH STEREO
5CH STEREO
The screen for the selected surround mode
appears.
• When “Default” is selected and the CURSOR
FF
button is pressed, “CINEMA EQ.” and “D.COMP.”
are automatically turned off, “ROOM SIZE” is set to
“medium”, “EFFECT LEVEL” to “10”, “DELAY
TIME” to “30 ms” and “LFE” to “0 dB”.
• The “ROOM SIZE” expresses the expansion effect
for the different surround modes in terms of the size
of the sound field, not the actual size of the listening
room.
DELAY TIME:
In the matrix mode only, the delay time can be set
within the range of 0 to 300 ms.
SW ATT:
This is the parameter for reducing the level of the
subwoofer channel when playing in the EXT. IN input
mode. Depending on the player you are using, the
subwoofer channel’s playback level may seem too
high. If so, set “SW ATT” to “ON”.
For DENON players, use with the default settings
(“OFF”).
Subwoofer ON/OFF:
The subwoofer output can be controlled directly.
ROOM SIZE:
This sets the size of the sound field.
There are five settings: “small”, “med.s” (medium-
small), “medium”, “med.l” (medium-large) and
“large”. “small” recreates a small sound field,
“large” a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower
the level if the sound seems distorted.
2 Surround parameters y
EFFECT:
This parameter turns the effect signals with multi
surround mode speaker effects on and off in the
WIDE SCREEN mode. When this parameter is
turned off, the SBL and SBR channel signals are
equivalent to the SL and SR channels, respectively.
LEVEL:
This parameter sets the strength of the effect
signals in the WIDE SCREEN mode. It can be set in
15 steps, from “1” to “15”. Set this to a low level if
the positioning or phase of the surround signals
sounds unnatural.
SB CH OUT:
• ON:
Playback is conducted using the surround back
speaker.
• OFF:
Playback is conducted without using the surround
back speaker.
NOTE:
This operation can be performed directly pressing
the SURROUND BACK button on the main unit’s panel.
Example: DSP surround simulation mode
Example: 7CH STEREO mode
• The “7CH STEREO” display changes as shown
below according to the surround back speaker
setting.