32
ENGLISH
Basic Operation
ENGLISH
Fader function
This function makes it possible to lower the volume of
the front channels (FL, C and FR) or the rear channels
(SL, SR, SBL and SBR) together. Use it for example to
adjust the balance of the sound from each position
when multi-channel music sources are played.
1
Press the ENTER button.
• Display the “Channel Vol.” screen.
2
Press the CURSOR
DD
,
HH
or ENTER
button to select “Fader”.
The channel switches in the order shown below
each time the ENTER button is pressed.
3
Press the CURSOR
FF
button to reduce
the volume of the front channels, the
CURSOR
GG
button to reduce the volume
of the rear channels.
Example: When “FRONT” is selected
The fader function does not affect the subwoofer
channel.
• The channel whose channel level is adjusted lowest
can be faded to –12 dB using the fader function.
• If the channel levels are adjusted separately after
adjusting the fader, the fader adjustment values are
cleared, so adjust the fader again.
Remote control unit
Operating DENON audio
components
1
Press the MODE SELECTOR buttons to
select the component you want to
operate.
3
2 SOURCE MENU
Operate the source.
2 SURROUND MENU
Operate the “Surround” mode.
2 NUMBER /
SYSTEM CALL MENU
Operate the “Number” or “System call”
mode.
2
Operate the audio component.
The function switches as shown below each
time one of the MODE SELECTOR buttons is
pressed.
AMP/Z2 : AMP, ZONE2
Z3/Z4 : ZONE3, ZONE4
TUN/D-TU : TUNER, D-TUNER*
CD/CDR : CD, CDR
TV/DBS :TV, DBS
VCR1/VCR2 : VCR1,VCR2
VDP : VDP
DVD/DVDR : DVD,DVDR
(* : This mode is for future use.)
Example:
Select “AMP” mode.
For details, refer to the component’s operating
instructions.
It may not be possible to operate some models.
Advanced Operation
Select “ZONE2” mode.
To Next Page
Loading...
