33
ENGLISH
Advanced Operation Advanced Operation
2. MD recorder (MD),
CD recorder (CDR),
Tape deck (TAPE) system buttons
6, 7 : Manual search
(forward and reverse)
2 : Stop
1 :Play
8, 9 :Auto search
(to beginning of track)
3 : Pause
0 ~ 9, +10 : Number
1. CD player (CD) system buttons
6, 7 : Manual search
(forward and reverse)
2 : Stop
1 :Play
8, 9 :Auto search
(to beginning of track)
3 : Pause
0 ~ 9, +10 : Number
OFF
ON
MODE SELECTOR
NUMBER
ENTER
Preset memory
The included remote control unit can be used to
operate devices of different brands by registering the
preset number corresponding to the brand of your
device.
For some models the remote control unit or the device
may not operate properly. In this case, use the learning
function ( page 35) to store your device’s remote
control signals in the included remote control unit.
For instructions on resetting the preset memory (
page 36).
1
Press the ON and OFF button at the
same time.
2
Press the 1 button to select preset
memory.
3
Press the MODE SELECTOR button for
the component you want to preset, then
press the
ENTER button.
3. Tuner system buttons
•, ª :Tuning up/down
BAND : Switch between AM
and FM bands
MODE : Switch between AUTO
and MANUAL
MEM :Preset memory
SFT :Switch preset channel range
CH +, – :Preset channel up/down
A ~ G :Preset channel range
1 ~ 8 :Preset channel
ENGLISH
2 Setup List
1:Preset memory
2:Learning setup
3:System call
4:Punch through
5:Light setup
6:Reset
Presetting is not possible for the AMP, ZONE2,
ZONE3, ZONE4, TUNER and D-TUNER modes.
The preset codes of an MD or tape player can be
recorded in the CDR mode so that the MD or
tape player can be operated ( page 33, 34).
It is only possible to set the preset memory for
one player (CDR, MD or TAPE).
To Next Page
Loading...
