Denon AVC-A11XV - PCM1804 (IC913) AUDIO P.W.B.; PCM1804 Terminal Function

37
ENGLISH
Advanced Operation Advanced Operation
ENGLISH
2 Resetting the system call buttons
1
Press the ON and OFF button at the
same time.
2
Press the 6 button to select resetting.
3
Press the 3 button to resetting the
system call buttons.
• All buttons of system call will light.
4
Press the MODE SELECTOR button you
want to resetting, then press the
ENTER
button.
• The set returns to the normal operating
mode.
2 Resetting the punch through setting
1
Press the ON and OFF button at the
same time.
2
Press the 6 button to select resetting.
3
Press the 4 button to resetting the punch
through setting.
•All punched through mode buttons will light.
4
Press the MODE SELECTOR button you
want to resetting, then press the
ENTER
button.
• The set returns to the normal operating
mode.
2 All reset function
1
Press the ON and OFF button at the
same time.
2
Press the 6 button to select resetting.
3
Press the +10 button.
• Clear the entire system memory, which will
restore the remote control unit to the factory
default settings. This operation will take
approximately 20 seconds.
Only use this if you wish to clear all customized
settings and memories and restore the unit to its
out-of-the-box factory default settings.
Multi zone music entertainment system
• When the outputs of the “ZONE2 (ZONE3)” OUT terminals are wired and connected to power amplifiers
installed in other rooms, different sources can be played in rooms other than the MAIN ZONE in which this
unit and the playback devices are installed. (Refer to ZONE2 (ZONE3) on the diagram below.)
• Settings can be made at “Power Amp Assign” in the “System Setup Menu” so that the same source as the
ZONE2 (ZONE3) pre-out terminals can be played from the speakers connected to the ZONE2 (ZONE3) speaker
terminals ( page 49, 50).
To control playback devices other than the ones above, either use that device’s remote control unit or preset
a separately sold programmable remote control unit.
2 When using the power amplifier as the MAIN ZONE output
• The AVC-A11XV is equipped with pre-out terminals for which the volume is adjustable and video output
terminals (composite and S-Video) as the ZONE2/ZONE3 output terminals.
• When using just one speaker in ZONE2 (ZONE3), select “Mono” at “Channel Setup” in the “System Setup
Menu” ( page 49). The sound in ZONE2 (ZONE3) is monaural. In this case, the ZONE2 (ZONE3) monaural
output is output from both the left and right channels of the ZONE2 (ZONE3) PREOUT connectors, so connect
to either one.
AVC-A11XV
DVD player
Input
Monitor
MAIN ZONE 7.1-channel system
SYSTEM REMOTE
CONTROL UNIT
RC-995
ZONE3 AUDIO OUT (VARIABLE OUT)
ZONE2
VIDEO OUT
ZONE3 VIDEO OUT
ZONE2 AUDIO OUT
(VARIABLE OUT)
C
FL FR
SL
SW
SR
B
B
SB
R
SB
L
Power Amplifer
Power Amplifer
ZONE 2
Monitor
ZONE 3
Monitor
: MULTI SOURCE AUDIO signal cable
: MULTI SOURCE VIDEO signal cable
Multi-zone playback using the ZONE2 and ZONE3 PREOUT terminals
Refer to CONNECTIONS ( page 18).
• For instructions on installation and operation of separately sold devices, refer to the devices’ operating
instructions.
[System configuration and connections example]
Using external amplifier.
OFF
ON
MODE SELECTOR
NUMBER
ENTER