Denon AVC-A11XV - LC89057 W-VF4-E (IC101-103) DIGITAL P.W.B.; LC89057 W-VF4-E Terminal Function; LC89057 W-VF4-E BLOCK DIAGRAM

38
ENGLISH
Advanced Operation Advanced Operation
ENGLISH
2 When using the power amplifier as the ZONE2/ZONE3 output
When the power amplifier is assigned to the ZONE2 or ZONE3 output channel at “Power Amp Assign” in the
“System Setup Menu”, the MAIN ZONE speaker terminals can be used as the ZONE2 or ZONE3 speaker out
terminals ( page 49, 50).
[System configuration
and connections example]
Using external amplifier as the ZONE2 and using this
AVC-A11XV internal amplifier as the ZONE3.
[System configuration
and connections example]
Using this AVC-A11XV internal amplifier as the ZONE2
and using external amplifier as the ZONE3.
AVC-A11XV AVC-A11XV
DVD player
Input
Monitor
Monitor Monitor Monitor
MAIN ZONE 5.1-channel systems
ZONE 2 ZONE 3
ZONE2
AUDIO OUT (VARIABLE OUT)
MULTI ZONE
SPEAKER OUT
ZONE2
VIDEO OUT
Power Amplifier
SYSTEM REMOTE
CONTROL UNIT RC-995
DVD player
Input
Monitor
Monitor
MAIN ZONE 5.1-channel systems
ZONE 2 ZONE 3
ZONE3
AUDIO OUT (VARIABLE OUT)
MULTI ZONE
SPEAKER OUT
ZONE2 VIDEO OUT
Power Amplifier
SYSTEM REMOTE
CONTROL UNIT RC-995
ZONE3
VIDEO OUT
ZONE3
VIDEO OUT
C
FL FR
SL
SW
SR
B
B
C
FL FR
SL
SW
SR
B
B
: MULTI SOURCE AUDIO signal cable
: MULTI SOURCE VIDEO signal cable
: SPEAKER cable
Multi-zone playback using the SPEAKER terminals
Refer to CONNECTIONS ( page 19).
FUNCTION ZONE3/REC SELECT
ZONE2 SELECT
1
Press the ZONE2 SELECT button to
display the “ZONE2 SOURCE” on the
display.
2
Turn the FUNCTION knob to select the
source you want to output appears on
the display.
3
Start playing the source to be output.
1
Press the ZONE3/REC SELECT button to
display the “ZONE3 SOURCE” on the
display.
•The MULTI indicator light.
2
Turn the FUNCTION knob to select the
source you want to output appears on
the display.
RECOUTZONE3
3
Start playing the source to be output.
Outputting a program source to an
amplifier, etc., in a ZONE2 room
(ZONE2 SELECT mode)
Outputting a program source to an
amplifier, etc., in a ZONE3 room
(ZONE3 SELECT mode)
For operating instructions, refer to the manuals
of the respective components.
The display switches as follows each time the
button is pressed.
For operating instructions, refer to the manuals
of the respective components.
• The signals of the source selected in the ZONE3
mode are also output from the VCR-1, VCR-2, VCR-3
and CDR/TAPE recording output terminals.
• Digital signals are not output from the ZONE2 and
ZONE3 audio output terminals.
• About the MULTI ZONE connections ( page 37,
38).
• Digital outputs of the OPTICAL2, 3 and 4 OUT
normally switch in association with the ZONE3/REC
SELECT mode, but if “ZONE2 SELECT” is selected
at “Digital Out Assign”, the source switches in
association with the “ZONE2 SELECT” mode for the
OPTICAL2 OUT digital output connector ( page
52).