39
ENGLISH
Advanced Operation Advanced Operation
ENGLISH
4
The volume of the outputs of the
different zones can be adjusted with the
VOLUME button on the remote control
unit.
Remote control unit operations
during multi-source playback
1
Select the zone which you want to
operate pressing the
MODE SELECTOR
buttons.
2
Press the SOURCE ON button to turn on
the zone power.
(Remote control unit)
3
Select the input source you wish to
output.
Playing Super Audio CDs with an
IEEE1394 cable
1
Select the input source to which
IEEE1394 was assigned at the
“IEEE1394 Assign” ( page 43, 44) in
the system setup.
• The IEEE1394 indicator lights.
light
2
Select the surround mode.
(Main unit) (Remote control unit)
3
Start playback on the selected
component.
• The DSD indicator lights.
light
For operating instructions, refer to the
component’s manual.
“DSD DIRECT” is shown on the display when
playing DSD 2-channel signals in the DIRECT
mode. “DSD MULTI DIRECT” is displayed when
playing DSD multi-channel signals in the DIRECT
mode (SB CH OUT “OFF”).
Example: ZONE2
Press the SOURCE OFF button to turn off the zone
power.
The output level can be controlled only if the
zone volume level is set “Variable” at “Volume
Control” in the “System Setup Menu” (
page 50).
DEFAULT VOLUME SETTING
ZONE2 : –40 dB
ZONE3 : –40 dB
The zone volume can be adjusted within the
range of –80 to 18 dB, in steps of 1 dB.
•Press the MUTING button to mute the audio
temporarily.
The muting level is same as set with “Volume
Control”.
• Cancelling muting mode:
Press the MUTING button again, or press the VOLUME
button on the remote control unit.
When playing DSD signals in the DIRECT or PURE
DIRECT mode, the DSD signals are converted into
analog signals. When playing in other surround
modes, the DSD signals are first converted into
PCM signals with a sampling frequency of 88.2
kHz. However, when playing DSD 2-channel
signals in the STEREO mode, they are converted
into PCM signals with a sampling frequency of
176.4 kHz. The input signal and playing status can
be checked by pressing the ON SCREEN button on
the remote control unit.
Example:
When DSD multi-channel signals are played in
the DIRECT mode
Example:
When DSD multi-channel signals are played in
the ROCK ARENA mode
Example: CD
(Main unit) (Remote control unit)
Example: DIRECT
Other function
To Next Page
Loading...
