Denon AVC-A11XV - LMC6772 AIM (IC903,909) DIGITAL P.W.B.; TC74 VHCT244 AFT (IC401) CONNECT P.W.B.; PQ015 EZ5 MZ (IC203) DIGITAL P.W.B.; SN65 LVDS2 DBVR (IC909) CONNECT P.W.B.

48
ENGLISH
Advanced Setup – Part 1 Advanced Setup – Part 1
ENGLISH
Setting the Manual EQ Setup
Allows you to adjust the tonal quality of the various
speakers (except the subwoofer) while listening to a
music source.
1
Press the CURSOR
DD
or
HH
button to
select the “Manual EQ Setup” at the
“Advanced Playback” menu, then press
the
ENTER button.
• Display the “Manual EQ” screen.
2
Press the CURSOR
FF
or
GG
button to
select the adjustment mode, then press
the
ENTER button.
All CH:
All channels can be adjusted simultaneously.
L/R CH:
The left and right channels of the pair of speakers
can be adjusted simultaneously.
Each CH:
The channels can be adjusted separately.
3
Press the CURSOR
FF
or
GG
button to
select the speaker to be set.
The display changes as follows.
FL/FR
SBL/SBR
C SLA/SRA
SLB/SRBSL/SR A+B
w Select “Each CH”
FL
SBR
1spkr
FR
C
SLA
SRA SLB
SRBSBL SR A+B SL A+B
SB
q Select “L/R CH”
When the surround back speaker setting is
set to “1spkr” at “Speaker Configuration”,
this is set to “SB”.
e Select “All CH”
In this case, speaker selection is not
performed.
If a value is already set for the FL channel, the
data stored for the FL channel is displayed.
4
Press the CURSOR
DD
or
HH
button to
select the frequency, then press the
CURSOR
FF
or
GG
button to adjust the
gain level.
5
Press the ENTER button to enter the
setting.
• The “Manual EQ” screen reappears.
6
Press the CURSOR
DD
or
HH
button to
select the “Exit”, then press the
ENTER
button.
• The “Advanced Playback” menu reappears.
Example:
When “L/R CH” is selected.
Each frequency can be adjusted the range from
–20 dB to +6 dB in 0.5 dB step.
Press the CURSOR
DD
or
HH
button to
select the “Exit”, then press the
ENTER
button.
• The “System Setup Menu” reappears.
7
Procedure for copying the “Flat”
correction curve
1
Press the CURSOR
DD
button to select
the “Base Curve Copy”, then press the
CURSOR
FF
button.
2
Press the CURSOR
FF
button to select
the “Yes”.
3
Press the ENTER button to enter the
setting.
• The “Manual EQ” screen reappears.
The type of the copied correction curve is
displayed in the upper right of this screen.
• “Base Curve Copy” is displayed after performing the
Auto Setup.
•To restore the settings to their defaults, select
“Default Yes
0 ”, then press the CURSOR
FF
button.
• If the “Auto Setup” procedure has not been
performed, this item is not displayed.
• The various settings applied in the auto surround
mode can be checked via the on screen display.
Simply press the ON SCREEN button.