52
ENGLISH
Advanced Setup – Part 1 Advanced Setup – Part 1
ENGLISH
Setting the Digital Out Assignment
The optical digital output connectors on the AVC-
A11XV’s rear panel (OPTICAL2 to 4 OUT) normally
function in association with the ZONE3/REC SELECT
mode. With this setting, the OPTICAL 2 OUT
connector can be used in association with the ZONE2
SELECT mode.
1
Press the CURSOR
DD
or
HH
button to
select the “Digital Out Assign” at the
“Option Setup” menu, then press the
ENTER button.
• Display the “Digital Out Assign” screen.
2
Press the CURSOR
FF
or
GG
button to
select whether to associate the
OPTICAL2 OUT connector to the
“ZONE3/REC SELECT” or “ZONE2
SELECT” mode.
3
Press the ENTER button to enter the
setting.
• The “Option Setup” menu reappears.
User Memory
The currently set settings (system setup, surround
parameters, etc.) can be stored in the memory. The
stored settings can be called out when needed.
1
Press the CURSOR
DD
or
HH
button to
select the “Setup Memory / Lock” at the
“Option Setup” menu, then press the
ENTER button.
• Display the “Setup Memory / Lock” screen.
2
Press the CURSOR
DD
or
HH
button to
select the “User Memory”, then press
the
ENTER button.
• Switch to the “User Memory” screen.
3
Press the CURSOR
FF
button to select
the “Yes”.
• About 30 seconds are required for the
settings to be stored in the memory.
Once the settings are stored in the memory,
“Load” is displayed and the settings can be
loaded.
4
Press the CURSOR
DD
or
HH
button to
select the “Exit”, then press the
ENTER
button.
• Return to the “Setup Memory / Lock”
screen.
The system setup settings can be locked so that they
cannot be changed easily.
1
Press the CURSOR
DD
or
HH
button to
select the “Setup Lock” at the “Setup
Memory / Lock” screen, then press the
ENTER button.
• Switch to the “Setup Lock” screen.
2
Press the CURSOR
FF
button to select
“ON”, to lock the system setup settings,
then press the
ENTER button.
• Return to the “Setup Memory / Lock”
screen.
3
Press the CURSOR
DD
or
HH
button to
select the “Exit”, then press the
ENTER
button.
• The “Option Setup” menu reappears.
4
Press the CURSOR
DD
or
HH
button to
select the “Exit”, then press the
ENTER
button.
• Finalize the setting and exit the “Option
Setup” menu.
Setup Lock
• When the setup lock function is activated, the
settings listed below cannot be changed, and “Setup
Locked” is displayed when related buttons are
operated.
• System setup settings
• Surround parameter settings
•Tone control settings
• Channel level settings (including test tones)
• RoomEQ
•To unlock, press the SETUP button again and display
the “Setup Lock” screen, then select “OFF” and
press the ENTER button.
To Next Page
Loading...
