Denon AVC-A11XV - 1 U-3667 DIGITAL P.W.B. UNIT (1;2)

58
ENGLISH
Advanced Setup – Part 2 Advanced Setup – Part 2
ENGLISH
Setting the Direct Mode Setup
1
Press the CURSOR
DD
or
HH
button to
select the “Direct Mode Setup” at the
“Auto Setup / Room EQ” menu, then
press the
ENTER button.
• Display the “Direct Mode Setup” screen.
Perform the ON/OFF setting of Room EQ when the
surround mode is “DIRECT” or “PURE DIRECT”.
2
Press the CURSOR
FF
or
GG
button to
select the “ON” or “OFF”.
3
Press the ENTER button to enter the
setting.
• The “Auto Setup / Room EQ” menu
reappears.
2
Press the CURSOR
FF
or
GG
button to
select the “Mic” or “V.AUX L”.
3
Press the ENTER button to enter the
setting.
• The “Auto Setup / Room EQ” menu
reappears.
7
Press the CURSOR
DD
or
HH
button to
select the “Exit”, then press the
ENTER
button.
• The “Parameter Check” screen reappears.
Setting the MIC Input Select
1
Press the CURSOR
DD
or
HH
button to
select the “Mic Input Select” at the
“Auto Setup / Room EQ” menu, then
press the
ENTER button.
• Display the “Mic Input Select” screen.
Sets whether the setup microphone is connected to
the PIN JACK (V.AUX L channel) connector or the MINI
JACK (SETUP MIC) connector.
Check the parameter
1
Press the CURSOR
DD
or
HH
button to
select the “Parameter Check” at the
“Auto Setup / Room EQ” menu, then
press the
ENTER button.
• Display the “Parameter Check” screen.
• The results of the measured items can be checked.
• The EQ parameters that were set in Auto Setup can
be checked.
• This item is displayed, after the measurement result
of the “Auto Setup / Room EQ” is decided.
2
Press the CURSOR
DD
or
HH
button to
select the items, then press the
ENTER
button.
• Display the verification screen.
For instructions on checking the results of each
item ( page 11).
4
Press the CURSOR
DD
or
HH
button to
select the Equalizer curve, then press
the
ENTER button.
• Display the “EQ Check” screen.
The display is only an approximate picture of the
response and that correction is happening at all
frequencies.
5
Press the CURSOR
FF
or
GG
button to
select the speaker channel.
6
If the check ends, pressing the CURSOR
DD
or
HH
button to select the “Exit”, then
press the
ENTER button.
• The “EQ Parameter Check” screen
reappears.
9
Press the CURSOR
DD
or
HH
button to
select the “Exit”, then press the
ENTER
button.
• The “Auto Setup / Room EQ” menu
reappears.
10
Press the CURSOR
DD
or
HH
button to
select the “Exit”, then press the
ENTER
button.
• The “System Setup Menu” reappears.
The results of the “Auto Setup”
procedure can be reset even if the
settings have been changed after
performing the “Auto Setup”
procedure:
Press the
CURSOR
DD
or
HH
button to
select the “Restore Yes
00
”, then press
the
CURSOR
FF
button.
8
3
Press the CURSOR
DD
or
HH
button to
select the “EQ Parameter Check”, then
press the
ENTER button.
• Display the “EQ Parameter Check” screen.