Denon AVC-A1XV - Remote Control Unit Operations During Multi-source Playback

153
Remote control unit operations during multi-source playback
1
Select the Zone which you want to operate using the mode selector
buttons.
RC-995
4
7
1
3
2
6
8
5
2
Press the SOURCE ON button to turn on the Zone
power.
• The multi zone power indicator on Main unit is
light.
Press the SOURCE OFF button to turn off the
Zone power.
The multi zone power indicator on Main unit is off.
(Remote control unit)
3
Select the input source you wish to output.
4
Select the input mode. (only ZONE2 mode)
• Selecting the analog mode
Press the ANALOG button to switch to the analog
input.
• Selecting the digital mode
Press the INPUT MODE button to switch to the
digital input.
(Remote control unit)
(Remote control unit)
5
The volume of the outputs of the different zones can
be adjusted with the VOLUME + and – buttons on
the Remote control unit.
The output level can be controlled only if the zone
volume level is set “variable” at “7-3. Volume Control” in the System Setup Menu. (See pages 101, 102)
DEFAULT VOLUME SETTING
ZONE2 : –40 dB
ZONE3 : –40 dB
ZONE4 : –40 dB
The Zone volume can be adjusted within the range of –80 to 18 dB, in steps of 1 dB.
However, when using with ZONE2 set to multi-channel (5.1- or 7.1-channel), the ZONE2 volume can be adjusted
in steps of 0.5 dB. (See pages 92~95)
(Remote control unit)
6
Use this to mute the audio temporarily.
Press the MUTING button.
The Muting level is same as set with “7-3. Volume Level”.
Cancelling MUTING mode.
Press the MUTING button again, or press the volume up or down buttons on the remote control.
(Remote control unit)
7
To combine the sound being played in ZONE2 with the desired image:
Press the Remote control unit’s ZONE2 VIDEO SELECT button until the desired image appears on the ZONE2
monitor out.
The video source selected with the video select function is stored in the memory for the different ZONE2 input
sources.
Canceling simulcast playback.
Select “SOURCE” using the ZONE2 VIDEO SELECT button.
(Remote control unit)
Example: ZONE2
(Remote control unit)
(Remote control unit)
8
On screen display
Each time an operation is performed, a description of that operation appears on the display
connected to AVC-A1XV’s ZONE2 MONITOR OUT jack. Also, the unit’s operating status can
be checked during playback by pressing the Remote control unit’s ON SCREEN button.
Such information as the position of the input selector and the surround parameter settings is output in sequence.
For details, see page 133.
(Remote control unit)