or
(Remote control unit)
• This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the
power is switched off.
This function eliminates the need to perform complicated resetting when the power is switched on.
• The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage from when the Main unit’s
power switch is off and with the power cord disconnected.
In very rare instances, the AVC-A1XV internal microprocessor might lock up, or otherwise cause mis-operation. This might be caused due to an
AC line surge or line spike noise, or by static electric discharge on or nearby the unit, or to connected components. If the condition cannot be
corrected by powering off the unit, including disconnection of the AC cord for a period of ten minutes and subsequent re-connection, then the
unit may have to be re-initialized. Doing so will restore the microprocessor to its original out-of-the-box state, with all custom memories and
settings erased, and the original factory default settings restored. Only use this procedure if you are sure that the microprocessor requires re-
initialization.
1
Switch off the unit using the Main unit’s power operation
switch.
2
Hold the following STANDARD button and HOME THX
CINEMA button, and turn the Main unit’s power operation
switch on.
3
Check that the entire display is flashing with an interval of
about 1 second, and release your fingers from the 2 buttons
and the microprocessor will be initialized.
NOTES:
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the settings are reset
to the default values (the values set upon shipment from the
factory).
To Next Page
Loading...
