Denon AVC-A1XVA - Outputting a Program Source to Amplifier, Etc., in a ZONE2 Room (ZONE2 SELECT Mode); Outputting a Program Source to Amplifier, Etc., in a ZONE3 or ZONE4 Room (ZONE3, ZONE4 SELECT Mode)

171
[4] Outputting a program source to an amplifier, etc., in a ZONE2 room (ZONE2 SELECT mode)
1
Press the ZONE2 SELECT button.
2
Select the source you want to output
appears on the set’s display.
3
Start playing the source to be output.
• For operating instructions, refer to the manuals of the
respective components.
2 1
(Main unit)
(Main unit)
ZONE2 SOURCE
DVD
[5] Outputting a program source to an amplifier, etc., in a ZONE3 or ZONE4 room (ZONE3, ZONE4 SELECT mode)
2
With “ZONE3 SOURCE” displayed, turn
the FUNCTION knob and select the
source you wish to output.
• The MULTI indicator light.
• The display switches the selected
source.
3
Start playing the source to be output.
• For operating instructions, refer to the manuals of the
respective components.
2 1
ZONE3 SOURCE
DVD
NOTES:
• The signals of the source selected in the ZONE3 mode are also
output from the VCR-1, VCR-2, VCR-3, VCR-4 and CDR/TAPE
recording output jacks.
• Digital signals are not output from the ZONE3 and ZONE4 audio
output jacks.
• Refer to pages 166 ~ 170 about the MULTI ZONE connections.
1
Press the ZONE3/4/REC SELECT button.
The display switches as follows each
time the button is pressed.
ZONE4ZONE3
(REC OUT)
The ZONE4 SELECT can also be set with a method similar to the
above.
(Main unit)
(Main unit)