o
Recording custom macro operations
1
Press and hold RC SETUP for more than 3 seconds.
“SETUP” and p indicator flashes twice on the remote control unit.
2
Use ui to display “MACRO” on the remote control unit
and press ENTER.
3
Use ui to display “MAN” on the remote control unit
and press ENTER.
4
When “MCNo” appears on the remote control unit,
press the MACRO A – D button that you want to set.
5
Press the buttons to be stored one by one.
The step number for the storing procedure and mode are alternately
displayed on the remote control unit.
NOTE
0
You cannot store the macros for the ZONE SELECT button.
6
Press RC SETUP to exit the macro function.
“OK” flashes four times on the remote control unit and the normal
operation mode is restored.
Contents Connections Playback Settings Tips Appendix
271
Front panel Display Rear panel Remote Index
To Next Page
Loading...
