DTS sound is not output.
0
Check that the digital audio output setting on the connected device is set to “DTS”.
Dolby TrueHD, DTS-HD, Dolby Digital Plus audio is not output.
0
Make HDMI connections. (v p. 37)
0
Check the digital audio output setting on the connected device. On some devices, “PCM” is set by default.
Dolby PLg mode or DTS Neo:6 mode cannot be selected.
0
It cannot be selected when “Speaker Config.” - “Surround” is set for “None”. (v p. 155)
0
Dolby PLg or DTS Neo:6 cannot be selected when using headphones.
Audyssey MultEQ
®
, Audyssey Dynamic EQ
®
and Audyssey Dynamic Volume
®
cannot be selected.
0
These cannot be selected when you have not performed Audyssey
®
Setup. (v p. 144)
0
Switch to a sound mode other than “Direct”. (v p. 93)
0
These cannot be selected when using the headphones.
“Restorer” cannot be selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
surround, “Restorer” cannot be used. (v p. 124)
0
Switch to a sound mode other than “Direct”. (v
p. 93)
Contents
Connections Playback Settings Tips Appendix
186
Front panel Display Rear panel Remote Index
To Next Page
Loading...
