Denon AVR-X1800H User Manual

Changing the speaker settings to
match the listening environment
(Speaker Preset)
Two speaker settings can be saved to suit the environments where you
use your speakers.
1
Press OPTION.
An option menu screen is displayed.
0
When the input source is “HEOS Music”, an option menu for
online music is displayed. Select “AVR Options…”, then press
ENTER.
2
Use cursor Up/Down to select “Speaker Preset”, then
press ENTER.
The “Speaker Preset” screen is displayed.
3
Use cursor Left/Right to set the preset.
Preset 1
(Default):
Use Preset 1.
Preset 2: Use Preset 2.
0
This function can be used in the following cases.
0
Adjust the speaker settings manually after setting “Speaker Preset” to “Speaker
Preset 2”.
0
Save the result to “Speaker Preset 2” after performing Audyssey
®
Setup for a
second time.
Contents Connections Playback Settings Tips Appendix
116
Front panel Display Rear panel Remote Index

Denon AVR-X1800H Specifications

General

Amplifier Channels	7.2
HDMI Version	2.1
HDCP Support	2.3
eARC	Yes
Dolby Atmos	Yes
DTS:X	Yes
Dolby Surround	Yes
DTS Neural:X	Yes
Bluetooth	Yes
AirPlay 2	Yes
HEOS Multi-Room	Yes
Input Sensitivity/Impedance	200 mV / 47 kohms
Supported Audio Formats	MP3, WMA, AAC, FLAC, ALAC, WAV, DSD
Power Output per Channel	80W (8 ohms, 20Hz - 20kHz, 0.08% THD)
HDMI Inputs	6
HDR Support	HDR10+, Dolby Vision, HLG
Wi-Fi	Yes
Phono Input	Yes
Frequency Response	10Hz - 100kHz
Total Harmonic Distortion	0.08%
Signal-to-Noise Ratio	98dB