Manual Setup
Perform when setting the speakers manually or when changing settings
made in Audyssey
®
Setup.
0
If you enable new speakers in the Speaker Layout menu after
performing Audyssey
®
Setup, you will no longer be able to select
Audyssey MultEQ
®
XT, Audyssey Dynamic EQ
®
or Audyssey Dynamic
Volume
®
. (v p. 162)
0
Changing the following settings:
Distances / Levels / Crossovers settings will not disable Audyssey
®
or
require running Audyssey
®
Setup again.
0
“Manual Setup” can be used without changing the settings. Please set if
necessary.
Speaker Layout
Select a suitable speaker layout for your speaker system.
o
Amp Assign
Select the power amplifier usage method to match your speaker
system.
You need to configure the detailed settings for the speaker
configuration in accordance with the selected mode. Select Amp
Assign configure the corresponding detailed settings.
7.1ch:
Settings to assign all power amplifier within
this unit to MAIN ZONE to play back up to
7.1-channels.
5.1ch + ZONE2
(Default):
Setting to assign the unit’s built-in power
amplifier for ZONE2 and output the audio in
stereo.
5.1ch (Bi-Amp):
Setting to use the front speakers via the bi-
amp connection.
5.1ch + Front B:
Setting for playback using a second front
speaker. You can switch the playback
between front speaker A and B according
to your liking. Switch the front speaker
using “Front Speaker” in the menu.
(v p. 198)
Contents Connections Playback Settings Tips Appendix
189
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
