Denon AVR-X2300W User Manual

6
When the following screen is displayed, select “Begin
Test” and then press ENTER.
Start the measurement of the first position.
.
Ear Height
stopping during the tests.
Select "Begin Test" to start the calibration.
Audyssey Setup
NOTE: You will hear a series of loud chirps starting and
Back
Begin Test
0
Measurement requires several minutes.
NOTE
0
If “Caution!” is displayed on TV screen:
0
Go to “Error messages” (v p. 191). Check any related items, and
perform the necessary procedures.
7
When the detected speaker is displayed, select “Next”
and then press ENTER.
.
:
:
:
:
:
NextRepeat Last Test
No
Surr. Back
Ye sSurround
Ye s
Subwoofer
Ye sCenter
Ye s
Front
Speaker Detection
Audyssey Setup
Contents Connections Playback Settings Tips Appendix
187
Front panel Display Rear panel Remote Index

Denon AVR-X2300W Specifications

General

Receiver type	-
Audio output channels	7.2 channels
Power output per channel (20-20KHz@8 Ohm)	95 W
HDMI in	7
Number of HDMI outputs	2
Wi-Fi	Yes