Denon AVR-X4400H - Page 130

Sound mode
Channel output
Front
L/R
Center
Surround
L/R
Surround
Back
L/R
Front
Height
L/R
Top Front
L/R
Top Middle
L/R
Top Rear
L/R
Rear
Height
L/R
Surround
Height
L/R
Top
Surround
Front
Dolby
Atmos
Enabled
L/R
Surround
Dolby
Atmos
Enabled
L/R
Back Dolby
Atmos
Enabled
L/R
Subwoofer
Multi Ch Stereo
SDDDz8 Dz8 Dz8 Dz8 Dz8 Dz8 Dz8 Dz8 Dz8 D
Rock Arena
SDDDz8 Dz8 Dz8 Dz8 Dz8 Dz8 Dz8 Dz8 Dz8 D
Jazz Club
SDDDz8 Dz8 Dz8 Dz8 Dz8 Dz8 Dz8 Dz8 Dz8 D
Mono Movie
SDDDz8 Dz8 Dz8 Dz8 Dz8 Dz8 Dz8 Dz8 Dz8 D
Video Game
SDDDz8 Dz8 Dz8 Dz8 Dz8 Dz8 Dz8 Dz8 Dz8 D
Matrix
SDDDz8 Dz8 Dz8 Dz8 Dz8 Dz8
Dz8
Dz8
Dz8
Dz8
Dz8
Dz8 Dz8 Dz8 Dz8 D
Virtual
S D
z1
The applicable sound mode includes “Dolby Surround” and sound modes that have “+Dolby Surround” in the sound mode name.
z2
The applicable sound mode includes “DTS Neural:X” and sound modes that have “+Neural:X” in the sound mode name.
z3
A signal for each channel contained in an input signal is output as audio.
z4 Audio is output when “Subwoofer Mode” in the menu is set to “LFE+Main”. (v
p. 231)
z5 Audio is not output when “Speaker Config.” - “Surr. Back” in the menu is set to “1 spkr”. (v
p. 224)
z6
For the best Auro-3D experience Surround Height speakers are recommended, however you may substitute Rear Height speakers from a Dolby Atmos speaker setup in
place of Surround Height speakers.
z7
This is output if an Auro-3D signal is input and the input signal contains Top Surround.
z8 Audio is output from the speakers specified in the “Surround Parameter” – “Speaker Select” settings. (v
p. 176)
Contents Connections Playback Settings Tips Appendix
298
Front panel Display Rear panel Remote Index