6
When the following screen is displayed, select “Begin
Test” and then press ENTER.
Start the measurement of the first position.
1
Audyssey Setup
Select "Begin Test" to start the calibration.
NOTE: You will hear a series of loud chirps starting and
stopping during the tests.
Do not stand or place any objects between the speakers
and microphone while the measurements are being
made.
Back
Begin Test
0
Measurement requires several minutes.
NOTE
0
If “ERROR” or “CAUTION” is displayed on TV screen:
0
Go to “Error messages” (v p. 223). Check any related items, and
perform the necessary procedures.
0
If the volume level for the subwoofer is not appropriate, an error message
is displayed. See “Subwoofer level error message and how to adjust”
(v p. 224).
7
When the detected speaker is displayed, select “Next”
and then press ENTER.
Audyssey Setup
Speaker Detection
Front Yes
Yes
1 spkr
Yes
No
Center
Subwoofer
Surround
Surround Back
Repeat Last Test Next
Contents Connections Playback Settings Tips Appendix
219
Front panel Display Rear panel Remote Index
To Next Page
Loading...
