Factory Restore
When the unit or the network functions do not work properly, operation may be improved by performing the Factory Restore.
Do this when the unit still does not work properly even after trying the steps for “Resetting factory settings” or “Resetting network settings”. (v p. 304,
305)
After performing the Factory Restore, various settings are reset to the default settings. Configure the network settings and update the firmware again.
WARNING
By initiating Factory Restore mode, you will be installing limited
recovery firmware on this unit. Functionality will remain limited
until a firmware update is performed over the Internet. Do not
perform a Factory Restore if you do not have this unit connected
to your home network.
1
Press X while simultaneously pressing SETUP and
DIMMER.
2
When “Restoring” appears on the display, release the
buttons.
When the Factory Restore is complete, “Completed” appears on the
display for about 5 seconds, and the unit automatically restarts.
0
This operation takes time because it requires reconnecting to the network,
restoring and updating the firmware.
0
If this operation does not improve the problem, contact our customer service
center.
NOTE
0
Do not turn off the power until the Factory Restore is complete.
Contents Connections Playback Settings Tips Appendix
306
Front panel Display Rear panel Remote Index
To Next Page
Loading...
Need help?
General
