Denon D-60 - Page 11

POWER button
Press this to turn the power for
the entire system on and off.
Operating the Cassette Decks
OPEN/CLOSE (4)
Press this to open and close the cas-
sette trays.
DECK 1/2
Press this to select the deck to be
operated.
Stop button (MH)
Press this to stop the tape.
Forward play button (P}
Press this to play or record in the
forward direction,
Reverse play button (4)
Press this to play or record in the
reverse direction.
REC/REC MUTE (recording mute but-
ton) (@)
To set to the recording mode when in
the stop mode, press this button, then
press either the “Pb” or “4” button.
When pressed during the recording or
recording pause mode, a blank section
of approximately 5 seconds is created
on the tape, after which the deck is set
to the recording pause mode.
Rewind button (44)
Press this to rewind the tape.
Fast-forward button (>>)
Press this to fast-forward the tape.
All operations marked {R] from the following
page on are possible using the remote
control unit.
REMOTE CONTROL UNIT
CT} Power RC-148
NOTE:
if the open/close button on the remote
control unit is pressed and the disc tray
is opened or closed when no disc is
loaded, the remote control operation is
given priority, and nothing will happen
when the play button or other buttons
on the main unit are pressed.
If this happens, press the open/close
button on the main unit before using it.
Operating the Receiver
SLEEP
Press this to set the sleep timer.
PRESET
Press these to tune in preset stations.
MUTE
When pressed once, the sound is
muted, and when pressed again, the
volume returns to the previous set-
ting.
EQ
Press this to select an equalizer setting
suitable for the type of music you are
currently listening to.
FUNCTION (function selector)
Press this to switch the function be-
tween TUNER, TAPE, CD, PHONO and
LINE.
VOLUME
Use these to adjust the volume. The
volume decreases when the V button
is pressed, and increases when the A
button is pressed.
Operating the CD Playe
OPEN/CLOSE (4)
Press this to open and close the disc
tray.
TIME
The time on the display switches as
follows each time this button is press-
ed: Remaining time per track — Total
remaining time -+ Elapsed time per
track.
PROGRAM
Use this for programming tracks.
Stop button (Mi)
Press this to stop playback.
Play button (P)
Press this to start playback.
Manual search reverse button (44)
Manual search forward button (P>}
Use these to forward or reverse the
cD.
Auto search reverse button (i¢¢)
Auto search forward button { PPI)
Use these to search for the beginning
of the desired track.
ENGLISH
[6] SETTING THE CURRENT TIME
Setting the Current Time (The time is displayed in the 24-hour mode)
(3) [)
DENON ctascun comonent Srseu Steno mECEVEM 0-80
=D «GD —©
Example: Setting the time to 7:30 (The time is displayed in the 24-hour mode.)
Press the POWER ON/
R
STANDBY button to turn ON/STANDBY
the power on.
Press the CLOCK/DISPLAY
button, and hold it in for CLOCK/
at lease 3 seconds. DISPLAY
TUNING
Use the UP and DOWN
buttons to set the hours.
Press the ENTER/NEXT ENTER
7
button.
NEXT
Pra
n
NIZNIZ
TUNING
Use
the
UP
and
DOWN
ni
°
3
g
buttons to set the minutes. 7 ANN
ENTER! ‘ y
NEXT
Press the ENTER/NEXT
button at the sound of a
time service's chime.
The time display stops
flashing, and the clock
starts counting the time.
11