Denon D-60 - Page 16

Programmed Playback (remote control only)
Use this function to set certain tracks to play in any order you want. |
Example: Programming track 3 to play first, track 5 to play second
CD with 25 tracks and a total playing time of 41 minutes, 37 seconds
Press the PROGRAM
button on the remote
control unit.
Prass the l€4 or
DPI button to set
track 3.
Press the PROGRAM
button on the remote
control unit.
Press the 44 or
PPI button to set
track 5.
Press the PROGRAM
button on the remote
control unit.
Press the > (play)
button.
REMOTE CONTROL UNIT
RO-148
TRACK
PROGRAM
es YY I"F7
PROGRAM
PROGRAM
TRACK
PROGRAM
83 G0O"*OT
FLAT
~~
The numbers of the programmed tracks turn off once the
tracks are played.
The time display will read “—— M— — S” if a track witha
number of 31 or greater is set in the program.
With this set, up to 20 tracks with numbers between 1 to
93 can be set in the program.
If you attempt to set a track number greater than the
number of tracks on the disc, that track number will not be
displayed when the button is pressed.
Programming is also possible while the disc tray is open.
In this case, track numbers greater than the number of
tracks on the disc can be programmed, but these are
ignored when the disc is played.
No sound is produced for 4 seconds between tracks. This is
so that 4-second blanks are created between tracks when
programmed tracks are recorded on tapes.
© The entire program is cleared when the disc tray is opened
or closed (by pressing the & button).
e if you make a mistake when setting the program, either
press the OPEN/CLOSE key or the STOP key twice and
start over.
® Operations possible during programmed playback
The quick search, pause and skip monitor functions can be
used during programmed playback. For the quick search
function, to move to the beginning of the previous track,
press the I€€ button once, then once again while the time
display reads “DO MOOS".
To move to the beginning of the following track, press the
PPI button once, regardless of the time display.
@ Set the program when the CD player is in the stop mode.
¢ Programming is not possible when the CD is playing.
¢ To change the track number continuously in step 4 above, press the €4 or }P button.
16