Denon D-60 - Page 18

18
uto Heverse
This
deck
is
equipped
with
an
auto
reverse
mechanism,
so
cassette
tapes
can
be
played
and
recorded
on
both
sides
or
played
continuously without having to turn them over.
BB Direction of tape travel
This deck has two play buttons, one for the forward direction
(front side) and another for the reverse direction (back side).
The side being played can be changed during playback by
pressing the opposite play button.
@ Reverse mode
Set the reverse mode switch (REV. MODE) as follows:
@ Single-side recording/playback mode ( —— )
In this position, only the front side or the back side of the
cassette tape is played or recorded. (The tape stops
automatically when the end of that side is reached.)
© Double-side (reverse) recording/playback mode { => )
In this position, when the end of the front side is reached,
recording or playback automatically switches to the back
side and continues from there. (The tape stops automati-
cally when the end of the back side is reached.}
¢ Continuous mode ( > }
Playback continues until the STOP button is pressed, but
stops automatically after both sides have been piayed five
times.
e@ Relay playback mode
When tapes are loaded in both decks
Playback continues from deck 1 onto deck 2, as shown on
the diagram at the right.
(Side which is visible
when loaded in
cassette tray.)
Start from
front side — a amp [eo Auto stop
Start from
=e
Os] m—— (PO) saz
Auto stop
ron soo
[Os]
mm
PO
9
Auto
stop
[Os
oe
(eS)
end
* If you start playing or recording from the back side, the
tape will stop automatically at the end of the back side.
Lad
i a
Le
* The reverse recording/playback mode ({ = ) is set
automatically during recording.
--- 70)-4
Reverse
Deck 1
Start from
r front side
I rc =
| Relay
i.
Lo
ei fe
Deck 2
3
i?
fio]
PLAYING
CASS
ETTE
TAPES
(Single
Side
Playback,
Double
Side
Playback
and
DENON oersons comontnt sramucartaeg casser rar ofct
@ For both Deck 1 and Deck 2
Continuous Playback)
@
When
operating
from
the
remote
control
unit,
operation
switches
between
Deck
1
and
Deck
2
each
time
the
DECK
1/2
button
is
pressed.
The
indicator
for
the
selected
deck
(DECK
1
or
DECK
2)
lights.
Press the OPEN/CLOSE, and load a
recorded tape into the tray.
Refer to Page 17.
Set the reverse mode selector.
Refer to Page 8.
Set the Dolby NR selector.
Refer to Page 8.
Press the play button (> or 4).
Press the IM button to stop playback.
These operations can be performed from the remote control unit once tapes are loaded.
Single side playback © Double side playback Continuous playback
eT
DOLBY NR
ON
Set the selector to “ON” for
tapes recorded in Dolby NR.
Playback begins in the direc-
tion of the button which was
pressed.
Bi ea te cat tae