Denon D-60 - Page 5

[3] CONNECTIONS
¢ Do not plug the power cord into the power outlet until aii
connections are completed. Connect properly as shown in
the diagram.
@ Check the right and left channels, and be sure to connect
the speaker's L terminals to the amplifier’s L terminais, the
speaker's R terminals to the amplifier's R terminals.
e Be sure to insert the plugs securely. Incomplete connec-
tions can cause noise.
e This system includes digital circuitry, so it may cause
problems with the colors on a TV, If so, turn the system's
power switch off.
[4] Assembling the Loop Antenna
Assemble the included AM loop antenna as shown in the
diagram.
AM loop antenna
Antenna stand
@ Undo the clasp.
@ Insert the AM loop antenna into the antenna stand.
e Note that if the input jacks selected with the FUNCTION
selectors are open {if nothing is connected), the sound may
leak to another component connected to different input
jacks.
e Note that grouping connection cords (pin-plug cords)
together with power cords or setting them near power
transformers can cause noise.
e This system consists of precision components using
microprocessors. Avoid using it in places where there is
much external noise. The system may not operate properly
if used in is such places, but this is not a problem with the
system. If it should function improperly, perform the
desired operation once again.
[2] Connecting the System Connector Cord
When connecting the system connector cord, press on
the center of the connector plug until you hear a click.
When disconnecting the system connector cord, press
the sides of the connector plug towards the middie and
pull.
% t
Connector plug
Connector cord
NOTE
®@ Note that disconnecting by pulling on the cord can
damage it.
@ Keep the power cord unplugged when connecting
the system connector cord.
e Note that connecting the system connector cord
when the power cord is plugged into a power outlet
may result in improper operation.
3]
Connecting
the
Included
Antenna
Adapter
Connect
the
coaxial
cable
and
antenna
adapter
using
the
procedure
on
the
diagram
below.
PULL ri
3
em
iC ‘
PULL ANTENNA ADAPTER
*,
CLAMP
>
aL 75 ohm COAXIAL CABLE
SYSTEM CONNECTIONS
Keep the FM and AM antenna wires away from the
system connector wire to prevent noise from entering
the antennas.
Speaker system connections
Connect the speaker system for the left channel (the left
side as seen from the front) to the L terminals, the
speaker system for the right channel to the R terminals.
Connect the speaker systems before inserting the
system connector.
AM OUTDOOR
ANTENNA
(Left channel) (Right channel)
300 ohm FM OUTDOOR ANTENNA
ANTENNA
FM INDOOR ANTENNA 75 ohm
{an Accessory) ANTENNA
300 ohm
AM loop antenna
COAXIAL
FEEDER | CABLE
HY,
+ ower plug
= (aR)
a ()
+ AC 230 V 50 Hz,
ela) (8D) ac 240 V 50 Hz ,
i DE | itor U.K. mode)
(2) }] tPtug into a power outlet.) i
Power cord
{for U.K, model}
SYSTEM CDNNECTOR 2
‘THIS UNT SHALL GE USED ONLY FOR MODEL NO 0-60
WARNING: SHOCK HAZARD - 00 NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE - NE PAS DUVRIR
THIS UNTY SHALL BE USED ONLY FOR MODEL NO 0-40
WARMING SHOCK HAZARD - DO NOT OPEN
AVIS RISQUE DE CHOC ELECTRIQUE - NE PAS OUVAR
So ee eee ee