Denon D-60 - Page 9

ENGLISH
CD PLAYER DISPLAY
On this system, the receiver includes a multi-display.
This
display
indicates
various
types
of
information
for
different
modes
depending
on
which
section
of
the
system
is
being
used,
as
follows:
When listening to the radio or when using the timer .......0.--.eeeeecreeeees See diagram below.
When listening toaCbD ..., ... Refer to Page 9.
When listening to a tape .. Refer to Page 10.
Tape type and re-
maining time dis-
play
During the editing
function, c-00
lights and the
tape time is dis-
played.
These indicate the time display mode.
TOTAL lights when the remaining time for
all tracks is displayed.
SINGLE fights when the remaining time
per track is displayed.
This lights to indi-
cate that the timer is
set.
NOTE:
Track
number
display
DD
is
displayed
when
the
disc
data
cannot
be
read
properly.
When a disc is loaded:
e The total number of tracks is displayed in the stop mode.
e The track number is displayed in the play and program modes.
©
CCorJ3is
displayed
when
the
innermost
or
outermost
section
of
the
disc
is
reached
in
the
manual search mode.
e@ The timer standby mark “ iC) ” will not light if the
current time is not set.
This lights when signals
are received from the re-
mote contro! unit.
Time display
O0ODis displayed when the disc data cannot be read properly.
When a disc is loaded:
e The elapsed playing time is displayed in the stop mode.
e The elapsed time for the track currently playing is displayed in the play and pause modes.
e The elapsed time for the programmed tracks is displayed in the program mode.
The reception frequency,
function, time, and timer set-
tings are displayed here.
This indicates the band being
received [AM (MW and LW) or
FM] and the preset number
when presetting stations in
the memory.
(REPEAT AB!
PROGRAM lights
during the prog-
rammed = search
mode.
This lights when the
station is tuned in
properly.
> PLAY lights when the disc is
playing, and i! PAUSE lights
when in the pause mode.
When presetting stations in the memory : “MEMORY”
When setting the timer times : “ON” or “OFF”
When recalling a preset station : Preset number
When the sleep timer is operating : “SLEEP”
When an equalizer setting is selected : Equalizer mode
During muting : “MUTING”
* Normally the equalizer setting is displayed.
The indicators switch as follows
when the REPEAT button is pressed
in the play mode:
First press : REPEAT TRACK
Second press : REPEAT ALL
Third press : REPEAT
Fourth press : REPEAT {A)-(B)
Fifth press : None Display
During editing operations: “REMAIN”
During edited recording: “EDIT”
When no disc is loaded, when the disc is loaded
upside-down, or when the disc is heavily scratched or
dirty : “NO OISC”
During
the
editing
operation,
“EDIT
{A}
TAPE"
is
displayed
and
the
remaining
time
for
side
A
of
the
tape
is
indicated
on
the
time
section
of
the
display.
When
the
TAPE
SIDE
A/B
button
is
pressed,
“(A)”
turns
off,
”(B]”
turns
on,
and
the
remaining time for side A of the tape is indicated in the same way.
The > PLAY indicator lights when a disc is playing, and the Il PAUSE indicator
lights when the pause mode is set.