Denon DCD-F109 - 1.2.2. USB µ-com Update

34
t
When a le is not found
(5) After Version UP is completed, a tray is opened and it stops in
1.2.2. USBμ-com
(1) AC is turned on while pressing the
5
and
2
button same time on this unit.(Entering the Service mode)
(2) While displaying model name, when
9
and the POWER button are pressed simultaneously, the tray opens.
(3) If the
5
or
1
/
3
button is pushed and a tray is closed, a disc will be loaded and Version up will be started.
(4) "FileError" is displayed when not found upgrade le and the tray is opened.
q
During a le search
w
During a le check
e
During deletion
r
Writing
t
When a le is not found
(5) After Version UP is completed, a tray is opened and it stops in
NOTE:
Do not turn off the power or disconnect the AC cord while the rmware is being updated.
If rmware updating is not completed normally, some operations may no longer be guaranteed to work and it may not be
possible to update the rmware again.
If MAIN μ-com is not started, replace it.
S
YSTEM VUP ALL
F
ileEr ror
S
YSTEM VUP ALL
C
omple te
S
YSTEM VUP ALL
S
etDis c -> Close
S
YSTEM VUP ALL
F
ileSe arch
S
YSTEM VUP ALL
F
ileCh eck
S
YSTEM VUP ALL
E
rasig
S
YSTEM VUP ALL
W
ritin g
S
YSTEM VUP ALL
F
ileEr ror
S
YSTEM VUP ALL
C
omple te