Denon DHT-S516H - Controlling Your DHT-S516 H; Remote Control Setup; TV Sound Grouping

Controlling your DHT-S516H
DHT-S516H can be operated using the remote control unit of the TV.
1
Select “Remote Control”.
The setup below is not required when device control by HDMI is
active. (A check mark will be displayed by “HDMI CEC” in this case)
2
Select “IR Control”.
3
Select a DHT-S516H command you would like to
control by your remote controller.
TV Sound Grouping
Set when you want to play TV audio or external input audio from this unit
through a different HEOS device.
1
Select “TV Sound Grouping”.
n
Enable
Enables grouping.
n
Audio Delay
Sets the delay for the audio.
NOTE
0
The audio may cut out if the amount of delay is too short. Lengthen the amount of
delay if the audio cuts out.
Contents Setup Use Troubleshooting Status LED Appendix
54