Denon DHT-S516H - Deep Standby Mode; Turning Off the Device

o
Deep Standby
The device also has the ability to automatically enter “Deep Standby”
whenever the wired or wireless network connection is removed for
more than 60 minutes in "Quick Start Mode".
The front panel LED will turn off during Deep Standby. To “wake” a
DHT-S516H from Deep Standby,
0
Press the volume or mute buttons.
0
Input audio signal to Optical/Coaxial.
0
CEC (Consumer Electronics Control) command over HDMI/ARC
0
Press the button on your remote controller which you taught DHT-
S516H by “Controlling your DHT-S516H”.
NOTE
0
It may take around 40 seconds to wake up your DHT-S516H from the deep
standby.
0
You also push the mute button for 3 seconds, the device enters the Deep
Standby.
o
Off
To completely turn off the power to the device you must remove the
mains plug from the power outlet.
Contents Setup Use Troubleshooting Status LED Appendix
61