Distorted sound from the DHT-S516H
Solution Refer to Page
0
If the signal source is a volume-controlled output, turn it down a couple of steps from maximum. －
0
Check the signal source to be sure the distortion is not originating there. －
0
If DHT-S516H’s volume is set to its maximum, turn it down a few steps. －
Trouble teaching DHT-S516H remote control commands
Solution Refer to Page
Remember that while DHT-S516H can learn almost all IR (infrared) remote commands, there remain a few rare code formats that
cannot be taught (much like some engineers we know).
–
Television speakers keep getting turned back up
Solution Refer to Page
Disable the television’s speakers (usually a setup-menu option, but a rear-panel switch on some televisions). If this is not possible,
the problem is likely that the television responds to press-and-hold (ramping) volume commands more quickly than the DHT-
S516H; in this rare case use DHT-S516H’s front-panel or supplied remote to turn the DHT-S516H’s volume up.
–
Contents Setup Use Troubleshooting Status LED Appendix
63
To Next Page
Loading...
