Automatically turning on the power
according to the playback of the
playback device (Auto on control
function)
If you turn on the auto on control function and playback is started by the
playback device while this unit is on standby, the power of this unit is
automatically turned on and playback is started. In addition, if the power is
on, the input source is automatically switched according to the playback of
the playback device. The auto on control function can be set to on or off
for each input source.
1
Switch to the input source you want to set.
2
On the remote control unit, press the button that corresponds
to the input source you want to set for five seconds or longer.
Input source Button
TV (HDMI eARC/ARC) TV
HDMI IN HDMI
OPTICAL IN OPT
AUX IN AUX
The status LEDs in the display of the current input source blink three times.
Off
On
(Default)
Auto on control
function
[Ex.] Input source:
TV (HDMI eARC/ARC)
0
Even if the auto on control function is on for the optical input or AUX input, the input source
will not switch automatically during HDMI (eARC/ARC) playback.
0
When this unit is in deep standby mode, the auto on control function of the optical and AUX
inputs cannot turn on the unit. (v p. 30)
Contents
Connections Playback Settings Tips Appendix
32
To Next Page
Loading...
