Denon DN-HD2500 - Page 12

12
DN-HD2500
2.8 Heat_Run mode
The names of the files that can be played are
displayed on the Deck1 screen.
Turn the Deck1 PARAMETERS knob to select
the file, then press the PARAMETERS knob to
set the file.
The CUE ( ) button flashes red while
preparations for playing the selected file are
being made.
 "Heat_Run_Execute!" is displayed.
Once preparations for file playback on Deck1
are completed, the CUE ( ) button stops
flashing red, remaining lit.
Press the Deck1 PLAY/PAUSE ( ) button
to start heat run continuous playback.
--Deck1 operation--
Using the same procedure as with Deck1,
select and set the name of the file to be played
using the Deck2 PARAMETERS knob.
Once the file name is set, "Power Off/On Only"
is displayed.
Press the Deck2 PLAY/PAUSE ( ) button
to start heat run continuous playback.
If an error occurs when in the heat run mode,
the playback stop mode is set.
To end the heat run mode, press the CUE
( ) buttons on Decks 1 and 2 to stop
playback, then turn the power off.
No Mode Operation and Function Display



 


 

() 
 
 
()

   

  
 
    


 
   




   ()
  
No モード 操 作 と 機 能 表 示