Denon DN-HD2500 - Page 14

14
DN-HD2500
4
DECK2 SW CHK
mode
After “DECK1 SW CHK” mode completed,
press any Deck1’s button other than the
PARAMETERS knob, and then "DECK2 SW
CHK" mode screen appears.
To check only Deck2, turn the PARAMETERS
knob on either Deck1 or Deck2, select "DECK2
SW CHK" from the service mode's top menu,
then press the PARAMETERS knob to set.
"DECK2 SW CHK" mode screen appears. In
this case, checking of the Deck1 switches is
not performed after checking of the Deck2
switches is completed.
When the PARAMETERS knob is pressed
while the “DECK2 SW CHK” mode is being
executed, the service mode's top menu reap-
pears.
When buttons on Deck2 are pressed, the
checkbox of the corresponding button is high-
lighted.
If the checkbox is not highlighted, there is a
problem with that button.
Once all the buttons on Deck2 have been
checked, the results of checking are displayed.
Press the PARAMETERS knob, and then the
service mode’s top menu appears.
No Mode Operation and Function Display



  
  
 
 
    
   
  
 
 
 
   
  

 



 

 
  
No モード 操 作 と 機 能 表 示