Denon DRA-265R - Block and Level Diagrams; System Signal Flow; Signal Level Chart

SPECIFICATIONS
AMPLIFIER SECTION
Continuous Power Output
(DIN):
Power Bandwidth (IHF):
Total Harmonic Distortion:
Frequency Response:
input Sensitivity and
Impedance:
Maximum Input Level:
(at 1 kHz)
Signal to Noise Ratio
(IHF-A):
Tone Controls:
Loudness:
55 W +55 W (4 ohms, 1 kHz)
10 Hz ~ 40 kHz (T.H.D. 0.15% both channels
driven into 8 ohms)
0.03% (-3 dB at rated output, 8 ohms)
PHONO RIAA Standard Curve (Recording Output)
MM =. 20 Hz ~ 20 kHz + 0.5 dB
CD, VIDEO, 20 Hz ~ 50 kHz + 1.5dB
TAPE (at 1 W)
PHONO MM 2.5mV 47 kohms
CD, VIDEO, 150mV = 25 kohms
TAPE
PHONO MM 120 mV
PHONO MM 78 dB (at 5.0 mV input)
CD, VIDEO, 95 dB
TAPE
BASS + 10 dB at 100 Hz
TREBLE + 10 dB at 10 kHz
50 Hz/10 kHz, + 10 dB/+6 dB
TUNER SECTION
[FM] (note: pV at 75 ohms, 0 dBf = 1 x 10° W)
Receiving Range:
Usable Sensitivity:
Signal to Noise Ratio
(IHF-A):
Image Rejection:
Selectivity ( 300 kHz):
Frequency Response:
Stereo Separation
(at 1 kHz):
[AM]
Receiving Range:
Usable Sensitivity:
Signal to Noise Ratio:
General
Power Supply:
Power Consumption:
Power Outlet:
Dimensions:
Weight:
REMOTE CONTROL UNIT
Remote control system:
Power supply:
€xternal dimensions:
Weight:
87.5 ~ 108 MHz
0.9 pV (10.3 dBf)
MONO 82 dB
STEREO 78 dB
65 dB
55 dB
30 Hz ~ 15 kHz *92 dB
40 dB
522 ~ 1611 kHz
18uV
55 dB
AC 230 V 50 Hz
104 W
SWITCHED 100 W
434 mm (W) x 119 mm (H)
x 306 mm (D)
5.7 kg
RC-174
Infrared pulse system
3V DC Two size “AA” (R6)
dry cell batteries
60 mm (W) x 175 mm (H)
x 18 mm (D)
120 g (includes batteries)
Design
and
specifications
are
subject
to
change
without
prior
notice.
ENGLISH
13