18
ENGLISH
(5) Timer function
(when connected in a system with the D-F101 series)
2 The power can be set to turn on and off at a specific time or at the same time everyday, in any modes: tuner
(“TUNER”), CD player (“CD”), cassette deck (“TAPE”), MD recorder (“MD”) and timer recording (recording to the
cassette deck (“TU
→
TAPE”) or the MD recorder (“TU
→
MD”) from the tuner).
1
Press the SLEEP button.
2
Press the SLEEP button again while the
”SLEEP” indicator is flashing.
Example: To turn the power off after 50 minutes.
(This operation is only possible from the remote
control unit (RC-927).)
3
The previous display reappears after 5 seconds.
The “SLEEP” indicator remains lit, indicating
that the sleep timer is functioning.
Cancelling the Sleep Timer
Press the SLEEP button repeatedly until the “SLEEP”
indicator turns off.
The sleep timer is also canceled if the power operation
switch or the power operation switch on the remote
control unit is pressed, turning the system power off.
NOTE:
If a several timer operations are set at once, the sleep
timer has priority.
• The time is reset to “60” (60 minutes) if the SLEEP
button is pressed again while the sleep timer is
functioning.
RC-927
(system remote
control unit)
(6) Setting the Sleep Timer
2 With this function, the power can be set to turn off after 10 to 60 minutes, in steps of 10 minutes, using the remote
control unit.
10
SYSTEM FUNCTIONS
2 Operation is even easier when the components in the D-F101 series are connected to the DRA-F101 with system
connections. (For instructions on connections, refer to “CONNECTIONS” on page 6, 7.)
2 All the system function signals for operating the components in the D-F101 series are output from the DRA-F101, so
be sure to connect the DRA-F101 when making system connections.
2 The system functions will only work when the components of the D-F101 series are connected. They will not work
with other components.
2 When system connections are made, the system functions described below can be used.
(1) The system remote control unit (RC-927) included with the DRA-F101 can be used to perform the main
operations on the other components.
(2) The remote control signals of the other components are received by the DRA-F101’s remote sensor.
(3) Auto function selection:
The function automatically switches when the PLAY/PAUSE button (
1 3
) on the CD player (DCD-F101),
cassette deck (DRR-F101), and MD recorder (DMD-F101) is pressed, and playback begins.
(4) CD synchronized recording:
CDs can be recorded on the cassette deck (DRR-F101), MD recorder (DMD-F101) simply by pressing the CD SRS
button on the cassette deck.
(5) Simultaneous recording:
When the PLAY/PAUSE button (
1 3
) on the CD player (DCD-F101) is pressed while the cassette deck (DRR-
F101), MD recorder (DMD-F101) is set to the recording pause mode, recording starts automatically.
(6) Timer functions:
The timer functions on the stereo receiver (DRA-F101) can be used to start playback or record radio programs
(“air check”) at set times. The sleep timer can also be used.
2 For instructions on the various operations, refer to the components’ operating instructions.
To Next Page
Loading...
