Denon DRA-F101 - Adjustment Procedures; Idling Current Adjustment

6
ENGLISH
SPEAKER SYSTEM
SYSTEM
CONNECTOR
PRE
OUT
SUB
WOOFER
RECPB
MDTAPEINPUTS
RECPBDVD
/
AUXCDPHONO
1
AM LOOP ANT.
ANTENNA
2
L
+
-
R
SPEAKER IMPEDANCE 4~16
FM COAX.
75
L
R
AC OUTLET
230V 50Hz
SWITCHED
W MAX
R
L
R
L
R
L
L
R
L
R
L
R
R
L
R
L
R
L
R
L
R
L
DVD
B
R
L
(L)
Subwoofer
(R)
4
CONNECTIONS
2 When connecting, also refer to the manuals of the other components.
2 When connecting to the D-F101 series, make the system connections shown by dotted lines on the diagram below.
2 The DRA-F101 is not equipped with connection cords. Use the connection cords included with the components you are
connecting to the DRA-F101.
NOTE:
• To allow for heat dispersal, do
not place another component
or any other object directly on
top of the DRA-F101.
NOTE:
•
If noise is generated
when the ground wire is
connected, disconnect
the ground wire.
• When making system connections with the D-F101 series, connect
the system cord to the DRA-F101 system connector (either 1 or 2).
Also interconnect the other system components in the same way.
(System connections are indicated by dotted lines on the diagram.)
• The D-F101 series stereo
receiver (DRA-F101) is
equipped with a clock and timer
function, so be sure to connect
it to a wall power outlet to
which power is supplied
constantly.
Speaker system
MD recorder (DMD-F101)
Cassette deck (DRR-F101)
CD player (DCD-F101)
NOTES:
• Do not plug the power cords into the power outlets until all connections have been completed.
• Check the left and right channels and be sure to interconnect them correctly (R to R, L to L).
• Plug in the power cords securely. Incomplete connections will result in noise.
•
Use the AC OUTLET for audio equipment only. Do not use them for hair driers, etc.
• Do not clasp the connection cords together with the power cords or place them near other electric products. Doing so may
result in noise.
• The PHONO input jack is extremely sensitive. A booming sound may be produced from the speakers if the volume is turned
up when no turntable is connected.
• The sound of another component may be heard if no component is connected to the input jacks of the function selected
with the FUNCTION selector.
DVD player
Power plug
(for U.K. model)
Power plug
AC 230V, 50 Hz
(Plug into a power outlet)
Turntable
(with MM cartridge)
NOTE:
•
This unit cannot be used with MC cartridges directly. Use a head
amplifier or a step-up transformer with MC cartridges.