16
Operation Operation
Press [DAB/RDS].
The display switches as shown below each time the button is
pressed.
q Tuning Aid
The reception sensitivity of the currently tuned in
frequency is displayed.
The program can be received without noise
when the antenna mark ( ) stretches to the
right of the flashing cursor.
Use [8] or [9] to switch the tuned in
ensemble.
w Station Order
Use [
8] or [9] to resort the service list.
(The service list is created with the auto scan
function.)
MULTIPLEX ALPHANUMERIC
(In order of frequency) (In alphabetical order)
e Dynamic Range Control
Use [
8] or [9] to switch the dynamic range.
r DAB Version
The DAB module’s version is displayed.
Making the DAB settings
Press [TIME/DISPLAY].
The display switches as shown below each time the button is
pressed.
Perform steps 1 to 5 under “Tuning in DAB stations”
to tune in a DAB station.
2
1
q Data Label Segment
The text data included in the broadcast scrolls
across the display.
w Station Name
The service station name is displayed.
e Program Type
The category of the tuned in station is displayed.
r Ensemble Name
The ensemble name is displayed.
t Reception frequency display
The reception frequency is displayed.
y Signal Quality
The reception signal sensitivity is displayed (0 to
100).
If the reception signal sensitivity is 80 or
greater, the program can be received without
noise.
u Audio Information
The mode of the currently tuned in station and its
bit rate are displayed.
i Date and Time
The current date and time are displayed.
Press MENU/SET to set the clock for the timer.
Switching the reception information for the
currently tuned in DAB station
About the button names in this explanation
<>: Buttons on the main unit
[]: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
To Next Page
Loading...
