Denon DRA-F107 - MEASURING POINT AND WAVEFORMS; FRONT PCB; UPDATE PCB

ENGLISH

Getting Started Playback Setting the Timer Other Functions Troubleshooting SpecificationsSystem Functions
Button located on both the main unit and the remote control
unit BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control unit [BUTTON]
Symbols used to indicate buttons in this manual
GExampleH Setting the current time to 10:15 am
1
Press ON/STANDBY to turn the power on.
2
Press [MENU].
Various types of setting menus are displayed.
3
Use [u] or [i] to select “CLOCK SETUP”, then
press [ENTER/MEMO] or [p].
4
Use [u] or [i] to set the “hours”.
5
Press [ENTER/MEMO] or [p].
The “minutes” display flashes.
6
 Use [u] or [i] to set the “minutes”.
7
Press [ENTER/MEMO] or [p].
The current time is set, and the normal display reappears.
M E N U
C L O C K S E T U P
M E N U
C L O C K S E T U P
C L O C K S E T U P
1 0 : 0 0
C L O C K S E T U P
1 0 : 0 0
C L O C K S E T U P
1 0 : 1 5
C L O C K S E T U P
1 0 : 1 5
n Checking the current time when the power is on
Press [CLOCK].
Press once more and the display returns to its original condition.
n Checking the current time when the power is set
to standby
Press [CLOCK].
The current time is displayed for 10 seconds.
NOTE
The time cannot be set when in the standby mode. Turn on the power
first.
ON/STANDBY
ON/STANDBY
[MENU]
[CLOCK]
[ENTER/MEMO]
[uip]
Setup
Setting the Current Time
(24-Hour Display)
NOTE
• Insert the AC plugs securely. Incomplete connections could cause
noise.
Do not unplug the power cord before the power indicator turns off
and the DRA-F107 enters Standby mode.
• Only use the supplied power cord.
• Be sure the power cord is unplugged from the power outlet before
connecting or disconnecting it to the AC IN.
• The AC outlet is for use with audio components. Do not use it to
connect hair dryers or any equipment other than audio components.
Turning the Power On (vpage 12)
Once Connections are
Completed
Connecting the Power Cord
Connections Setup