Denon DRA-F107 - Presetting FM;AM Stations Manually; Listening to Preset Stations; Operating Using the PRESET;TUNING Buttons on the Main Unit; RDS (Radio Data System)

ENGLISH

Getting Started Connections Setup Setting the Timer Other Functions Troubleshooting SpecificationsSystem Functions
1
Tune in the station you want to preset.
2
Press [ENTER/MEMO].
The minimum number display “P– –” for the unregistered preset
flashes.
3
Select the number to be preset using [NUMBER] (0 ~
9, +10) or [CH –, CH +] and press [ENTER/MEMO].
The reception frequency and reception mode are preset and the
display switches to the station name input display.
4
Input the station name.
Names of up to 8 characters can be input.
• [u, i] button ······································ Selects the character.
• [p] button ·································Moves the cursor to the right.
• [CLEAR/DEL] button
···································Deletes the currently selected character.
b Characters that can be input.
A ~ Z, 0 ~ 9, ^ ’ ( ) * + , - . / = (space)
• If you do not want to input a station name, press [ENTER/MEMO]
without inputting anything else.
• If you make a mistake when inputting, perform the procedure
again. Whatever was previously input is overwritten.
5
Press [ENTER/MEMO].
The characters you have input are entered.
b To give names to other stations, repeat steps 1 to 4.
Use [NUMBER] (0 ~ 9, +10) or [CH –, CH +] to select the
preset number.
1
Press [MENU].
2
Select “TUNER SETUP” using [u] and [i], then
press the [ENTER/MEMO] or [p].
3
Select “MODE SELECT” using [u] and [i], then
press the [ENTER/MEMO] or [p].
4
Use [u] or [i] to select “PRESET MODE” or
“TUNING MODE”, then press [ENTER/MEMO].
<PRESET/TUNING> are set to operate in the selected
mode.
Presetting FM/AM Stations Manually
Up to 40 stations (total for FM and AM) can be preset.
RDS (Radio Data System)
RDS (works only on the FM band) is a broadcasting service which
allows a station to send additional information along with the
regular radio program signal.
The following four types of RDS information can be received with
this unit:
Operating using the PRESET/TUNING
buttons on the main unit
PRESET/TUNING
on the main unit can be used both for switching
the preset channel and for tuning.
Before operating them, switch the receiver to the “preset mode”
or “tuning mode” using the procedure below.
Listening to Preset Stations
TUNER Playback
1
Press TUNER to select “FM”.
2
Press [DAB/RDS].
3
Select “RDS SEARCH” using [u] and [i], then
press the [ENTER/MEMO] or [p].
4
Press [o p].
Automatically begin the RDS search operation.
b
If no RDS station is found, “NO STATION” is displayed.
1
Press TUNER to select “FM”.
2
Press [DAB/RDS].
3
Select “PTY SEARCH” using [u] and [i], then
press the [ENTER/MEMO] or [p].
4
Use [ui] to call out the desired program type.
5
Press [o p].
Automatically begin the PTY search operation.
b
If no program of the specified type is found, “NO STATION” is
displayed.
RDS Search
Use this function to automatically tune to FM stations that provide
the RDS service.
PTY Search
Use this function to find RDS stations broadcasting a designated
program type (PTY).
For a description of each program type, refer to “Program Type
(PTY)”.
Playback
See overleaf