Denon DRW-585 - Tape Copying and Synchronization; Dubbing Process (Deck A to B); Synchronized Recording Setup

ENGLISH
DUBBING (from deck A to deck B)-
• Switch on the amplifier or receiver.
• Set the Tape Monitor switch on your amplifier or receiver to the TAPE position.
© Press the POWER switch to the ON ( ) position.
© Load the cassette tape to be played in deck A and the one to be
recorded in deck B.
© Select the type of tape transport with the REVERSE MODE switch.
REV. MODE
Reverse mode
Operation
—
Dubbing is performed only for one side.
The decks stop when either deck A or B
reaches the end of the tape.
CD
The tape direction is reversed on each
deck when they reach the end of the tape.
(This is convenient for dubbing to a tape
with a different length.)
RELAY During dubbing of the side facing you, the
deck that first reaches the end of the tape
will stand by until the other deck reaches the
end of the tape, then both decks will reverse
the tape direction together.
(Depending on the manufacturer, the length of
tapes having the same recording time may differ
somewhat. Setting this mode permits the arrange¬
ment of the beginning portion of the opposite
side of the tape.)
©To begin normal speed dubbing, press the DU88ING SPEED NORMAL
button. The DUB indicator will light, at this time.
To high speed dubbing, press five U88ING SPEED HIGH button.
The HIGH indicator will light at time.
© To stop dubbing, press the st :» ( ■ ) button leek A or deck B.
• When deck A is in the buyback mode and deck B is in the stop
condition, setting deck B to t) recording pause mode will engage the
normal speed dubbing pause mode. Dubbing is then started by
pressing the PLAY button.
• When dubbing, the recording level and the Dolby NR recording will be
the same as those of the playback tape, regardless of the positions of
the INPUT LEVEL control and the DOLBY NR button.
• When listening to the playback sound during normal speed dubbing,
the DOLBY NR switch remains off even if it is pressed.
• The playback sound cannot be heard during high $pe@d dubbing.
• Operation using the REC/REC MUTE (•} and REC PAUSE (H) buttons of
deck B is permitted during normal s eed dubbing.
• Buttons other than the stop ( ■ ) button cannot be used during high
speed dubbing.
SYNCHRONIZED RECORDING FUNCTION-
• Convenient synchronized recording can be performed when used in
combination with a DENON CD player equipped for the synchronized
recording function.
• SYNCHRO Jack Connection Connect the SYNCHRO Jack with a DENON
CD player which is equipped with a SYNCHRO jack, then make a
synchronized recording. Use the connection cord supplied with this
cassette deck
• Switch on your amplifier or receiver and the CD player.
• Set the tape Monitor switch on your amplifier or receiver to the source
position.
CD PLAYER
12