Denon HEOS 7 HS2 - Initial HEOS Speaker Setup; Connect Mobile Device to Network; Prepare for Setup; Adding Speaker to Wireless Network

PROCEDURE AFTER REPLACING THE MICROPROCESSOR, ETC.
The procedure after replacing the u-COM (microprocessor), ash ROM, etc. is as follows.
PCB Name Ref. No. Description
Procedure after
Replacement
Remark
MAIN 60 Module PWB ASSY C/D
Be sure to update the rmware.
Be sure to rewrite the service region setting.
Be sure to rewrite the service Release Type setting.
Procedure after Replacement
A : The software has been written. The software is not written at the time of replacement.
B : The software has been written. The software may need to be rewritten by version updates. Check the version.
C : The software has not been written. Front LED is solid purple. Back LED is solid red.
See "2. Updating by USB", "3. Service region settings update procedures" and
"4. Service Release Type settings update procedures" for information on writing the software.
D : The software has been written.
See "2. Updating by USB", "3. Service region settings update procedures" and
"4. Service Release Type settings update procedures" for information on writing the software.
14